Ruby Tech FGS-2824 User Manual

RUB

Networking & Communications

TECHTECH

FGS-2824

R

Gigabit Switch

L2 Managed Switch

Gigabit Switch

FGS-2824:

8-Port TP+16-Port SFP GbE L2 Managed Switch

Key FeaturesKey Features

Standard compliance

---IEEE 802.3x Flow Control capability

---IEEE 802.1q VLAN

---IEEE 802.1p

RoHS Compliance
Performance

Switching capacity:

---24 Gigabit Ethernet ports with non-

blocking wise speed performance.

---8 K MAC addresses

---400KB on-chip frame buffer.

---Supports Jumbo frame support, up to
9K

---Broadcast/Multicast Storm
Suppression

---Port Mirroring
VLAN

---Port-base VLAN

---IEEE802.1q tag-base VLAN, up to 256
active VLANs

---Q-in-Q is an efficient method for
enabling Subscriber Aggregation.
VSM(Virtual Stacking Management)

---Support 16 devices stacking

---Multiple switches can be managed via
one IP address, just like software
stacking

---Low cost and easily to establish
network environment, not extra
hardware require.

---Not center on the physical location of
wiring closets
Qos

---Supports Layer 4 TCP/UDP Port and
ToS Classification

---Supports 802.1p QoS with two level
priority queue

---Supports priority in a Q-in-Q tag
Bandwidth Control

---Supports Ingress, Non-unicast and
Egress Bandwidth rating management
with a resolution of 1Mbps

Protocol

LACP

---Port trunking with 8 trunking group

---Up to 12 ports for each group.

BenefitsBenefits

QoS support layer 4 classification

The switch supports not only Layer 2 802.1p Priority Queue control, but also

supports programmable higher layer classification and prioritization to enable
enhanced Quality of Service (QoS) support for real time applications base on
information taken from Layer 2 to Layer 4, such as VoIP.

Port Mirroring Helps Supervisor Monitoring Network

Port mirroring copies traffic from a specific port to a target port. This

mechanism helps track network errors or abnormal packet transmission
without interrupting the flow of data.

Q-in-Q VLAN for performance & security

The VLAN feature in the switch offers the benefits of both security and

performance. VLAN is used to isolate traffic between different users and thus
provides better security. Limiting the broadcast traffic to within the same VLAN
broadcast domain also enhances performance. VLAN support enabling
advanced techniques such as "802.1Q-in-1Q" to be deployed.

802.3ad LACP for Bandwidth Aggregation

The Gigabit ports can be combined together to create a multi-link load-sharing

trunk. Up to 12 Gigabit ports can be set up per trunk for bandwidth up to
24Gbps, all traffic is aggregated based on MAC addresses, thus balancing the
traffic load. The switch supports up to 8 trunking groups. Port trunks are useful
for switch-to-switch cascading, providing very high full-duplex speeds.

802.1x Access Control Improve Network Security

802.1x features enable user authentication for each network access attempt.

Port security features allow you to limit the number of MAC addresses per
port in order to control the number of stations for each port. Static MAC
addresses can be defined for each port to ensure only registered machines
are allowed to access. By enabling both of these features, you can establish
an access mechanism based on user and machine identities, as well as
control the number of access stations.

802.1d Compatible & 802.1w Rapid Spanning Tree

For mission critical environments with multiple switches supporting STP, you

can configure the switches with a redundant backup bridge path, so
transmission and reception of packets can be guaranteed in event of any
fail-over switch on the network.

Broadcast/Multicast Storm Control

To limit too many broadcast/multicast flooding in the network, broadcast/

multicast storm control is used to restrict excess traffic. Threshold values are
available to control the rate limit for each port. Packets are discarded if the
count exceeds the configured upper threshold.

RUB

TECHTECH

Networking & Communications

R

Gigabit Switch

L2 Managed Switch

Gigabit Switch

GVRP/GARP

---802.1q with GVRP/ GARP
Multicasting

---Supports IGMP snooping including

active and passive mode
STP/RSTP

---802.1d/1w

Network Security

---802.1x access control

---Management Access Policy Control

Snmpv1,v2c Network Management

---RFC 1213 MIB (MIB-II)
Interface MIB
Address Translation MIB
IP MIB
ICMP MIB
TCP MIB
UDP MIB
SNMP MIB

---RFC 1757 RMON MIB
Statistics Group 1
History Group 2
Alarm Group 3
Event Group 9

---RFC 1493 Bridge MIB

---RFC 1643 Ethernet MIB

---Enterprise MIB

Overview

24-port Gigabit L2 Managed Switch is a
standard switch that meets all IEEE 802.3/
u/x/z Gigabit, Fast Ethernet specifications.
The switch included 8-Port 10/100/
1000Mbps UTP and 16-Port Gigabit SFP
Fiber management Ethernet switch. The
switch can be managed through RS-232
serial port via directly connection, or
through Ethernet port using CLI or Web­based management unit, associated with
SNMP agent. With the SNMP agent, the
network administrator can login the switch
to monitor, configure and control each
port's activity in a friendly way. The overall
network management is enhanced and the
network efficiency is also improved to
accommodate high bandwidth applications.
In addition, the switch features
comprehensive and useful function such
as QoS (Quality of Service), Spanning
Tree, VLAN, Port Trunking, Bandwidth
Control, Port Security, SNMP/RMON,
IGMP Snooping capability and Illegal
Access Report via the intelligent software.
It is suitable for both metro-LAN and
office application.

Technical SpecificationsTechnical Specifications

LED Description

LED Color Function

Global POWER Green -Lit when +5V power is coming up
Global CPU ACT Green -Blinks when CPU is active
Port LINK/ACT Green -Lit when connection with remote device
1-8 is good

-Blinks when any traffic is present
Port 10/100/ Green -Lit Green when TP link on 1000Mbps
1-8 1000Mbps /Amber speed

-Lit Amber when TP link on 100Mbps
speed

-Off when 10Mbps or no link occurs
Port LINK/ACT Green -Lit when SFP connection with remote
9-24 device is good

-Blinks when any traffic is present

Diagnostic LED

System LED Power
10/100/1000M TP Port Per Port LED Link/Act, 10/1001000Mbps
Gigabit SFP Module LED LINK/ACT

Network Interface

Configuration Connector Port
10/100Mbps TP Jack (RJ-45) TP(RJ-45) 1 to 8
1000Mbps SFP Fiber Module SFP 9 to 24

Hardware Spec.

Feature Detailed Description

Voltage 100~240 VAC, AC Line
Frequency 50~60 Hz
Consumption 30W
Ambient Temperature 0 to 40 C

Dimensions 44(H) x 442(W) x 209(D) mm
Weight 3kg

Humidity 5% to 90%
Safety Comply with FCC Part 15 Class A & CE

Mark Approval

Packing InformationPacking Information

Carton Dimensions (mm) pcs/Carton N.W (KG) G.W (KG)

530x512x345 5 20 21

Ordering InformationOrdering Information

Model

FGS-2824: 8-Port TP+16-Port SFP GbE L2 Managed Switch

Optional SFP Fiber Module (See note below)

SFP.LC 1000Base-SX GE SFP Multi-Mode Fiber Module 850nm
SFP.LC.M2 1000Base-SX GE SFP Fiber Module, LC Multi-

Mode 1310nm 2km
SFP.LC.S10 1000Base-LX GE SFP Single-Mode 10Km Fiber
Module 1310nm
SFP.LC.S30 1000Base-LX GE SFP Single-Mode 30Km Fiber
Module 1310nm
SFP.L5.S50 1000Base-LX GE SFP Single-Mode 50Km Fiber
Module 1550nm
SFP.BL5.S10 1000Base-LX GE SFP BiDi_LC 10Km Module Single
Fiber 1550nm, Type 1
SFP.BL3.S10 1000Base-LX GE SFP BiDi_LC 10Km Module Single
Fiber 1310nm, Type 2