RTS RT-2M User Manual

RT-2M (90007891000) Quick Start Guide

CONNECTOR CONNECTION

RJ-12

• Plug pins 2 and 5 into the Ch 1 input connector terminals.

• Plug pins 3 and 4 into the Ch 1 output connector terminals.

DB-9

• Plug pins 7 and 8 into the Ch 1 input connector terminals

• Plug pins 4 and 5 into the Ch 1output connector terminals.

INCLUDED PARTS:

• RT-2M Unit

• DB-9 Cable

NOTE: See the entire system diagram on reverse side.

RS-232 Cable Pinout

Step 1. Cable the Trunk Supervisor/TrunkEdit PC to the

RT-2M.

NOTE: In Trunk Supervisor, you must designate

the intercom and port number the RT-2M
sends the test signal over.

Step 2. Cable the RT-2M to the Frame.

To cable the RT -2M to the Frame, do the following:

1. Using the appropriate connector defined below, connect the

RT-2M to the Frame:

To cable the Trunk Supervisor/TrunkEdit PC to the
RT-2M, do the following:

1. Using the included cable, connect a COM port on

the Trunk Supervisor computer to the RS-232
Interface connector on the rear panel of the RT-2M.

2. Connect the other end of the connector to the trunking

LIT000306000 Rev. A 11/2008

connection port as defined in the Trunk Supervisor software.