Rti Vtx-t User Manual

It’s Under Control

®

Product Contents

• 1x VTX-T HDBaseT Transmitter

• 2x Mounting Ears

• 2x Mounting Screws

• 4x Plastic Cushions

• 1x RS-232 Cable

• 1x Power Adaptor (24V DC 1.25A)

• 1x Reference Guide

Safety Suggestions

Read and Follow Instructions. Read all safety and operating instructions before

operating the unit.

Retain Instructions. Keep the safety and operating instructions for future reference.
Heed Warnings. Adhere to all warnings on the unit and in the operating instructions.
Heat. Keep the unit away from heat sources such as radiators, heat registers, stoves, etc.,

including ampliers that produce heat.

Power Sources. Connect the unit only to a power supply of the type described in the
operating instructions, or as marked on the unit.
Power Cord Protection. Route power supply cords so that they are not likely to be
walked on or pinched by items placed on or against them, paying particular attention to the
cord plugs at power receptacles and at the point at which they exit from the unit.
Water and Moisture. Do not use the unit near water—for example, near a sink, in a wet
basement, near a swimming pool, near an open window, etc.
Object and Liquid Entry. Do not allow objects to fall or liquids to be spilled into the
enclosure through openings.
Servicing. Do not attempt any service beyond that described in the operating instructions.

Refer all other service needs to qualied service personnel.
Damage Requiring Service. The unit should be serviced by qualied service personnel

when:

The power supply cord or the plug has been damaged.
Objects have fallen or liquid has been spilled into the unit.
The unit has been exposed to rain.
The unit does not appear to operate normally or exhibits a marked change in

performance.

The unit has been dropped or the enclosure has been damaged.

Cleaning

To clean this product, lightly dampen a lint-free cloth with plain water or a mild detergent
and wipe the outer surfaces.

NOTE: Do not use harsh chemicals as damage to the unit may occur.

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. Any

changes or modications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the device.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment o and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit dierent from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received including interference that may

cause undesired operation.

Industry Canada Compliance Statement

This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received including interference that may

cause undesired operation.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s).
Son fonctionnement est soumis aux deux conditions suivantes:

1. Ce dispositif ne peut causer des interférences nuisibles.

2. Cet appareil doit accepter toute interférence reçue y compris des interférences qui

peuvent provoquer un fonctionnement indésirable.

Contacting RTI

For news about the latest updates, new product information, and new accessories, please visit
our web site at: www.rticorp.com

For general information, you can contact RTI at:

Remote Technologies Incorporated
5775 12th Ave. E Suite 180
Shakopee, MN 55379
Tel. [phone]
Fax [phone]
[e-mail]

Service & Support

If you are encountering any problems or have a question about your RTI product, please
contact RTI Technical Support for assistance (see the Contacting RTI section of this guide for
contact details).

RTI provides technical support by telephone or e-mail. For the highest quality service, please
have the following information ready:

• Your Name

• Company Name

• Telephone Number

• E-mail Address

• Product model and serial number (if applicable)

If you are having a problem with hardware, please note the equipment in your system, a
description of the problem, and any troubleshooting you have already tried.

*Please do not return products to RTI without return authorization.*

Limited Warranty

RTI warrants new products for a period of three (3) years (excluding consumables
such as rechargeable batteries which are warrantied for one (1) year) from the date of
purchase by the original purchaser (end user) directly from RTI / Pro Control (herein
referred to as “RTI”), or an authorized RTI dealer.
Warranty claims may be initiated by an authorized RTI dealer using the original dated
sales receipt or other proof of warranty coverage. In the absence of the receipt of
purchase from the original dealer, RTI will provide warranty coverage extension of six
(6) months from the date code of the product. Note: RTI warranty is limited to the

provisions set forth in this policy and does not preclude any other warranties oered by

third parties who are solely responsible for those other warranties.

Except as specied below, this warranty covers defects in product material and

workmanship. The following are not covered by the warranty:

• Product purchased via unauthorized sellers or internet sites will not be serviced­regardless of purchase date.

• Damages caused by accident, misuse, abuse, neglect or acts of God.

• Cosmetic damage, including, but not limited to, scratches, dents and normal wear
and tear.

• Failure to follow instructions contained in the Product Installation Guide.

• Damages due to products used in an application or environment other than that for
which it was intended, improper installation procedures or adverse environmental

factors such as incorrect line voltages, improper wiring, or insucient ventilation.

• Repair or attempted repair by anyone other than RTI and Pro Control or authorized
service partners.

• Failure to perform recommended periodic maintenance.

• Causes other than product defects, including lack of skill, competence or
experience of user.

• Damage due to shipment of this product (claims must be made to the carrier).

• Altered unit or altered serial number: defaced, modied or removed.

RTI is also not liable for:

• Damages caused by its products or for failure of its products to perform, including

any labor costs, lost prots, lost savings, incidental damages, or consequential

damages.

• Damages based upon inconvenience, loss of use of the product, loss of time,
interrupted operation, commercial loss, any claim made by a third party or made
on behalf of a third party.

• Loss of, or damage to, data, computer systems or computer programs.

RTI’s liability for any defective product is limited to repair or replacement of the
product, at the sole discretion of RTI.

In cases where the warranty policy conicts with local laws, the local laws will be

adopted.

VTX-T

HDBaseT Video Transmitter

Reference Guide

VTX-T HDBaseT Video Transmitter

The VTX-T HDBaseT Video Transmitter delivers an HDMI 1080p video signal over Cat5e/6 up to 328ft (100m) and
a 4K signal up to 230ft (70m) to the VTX-R HDBaseT Video Receiver. The VTX-T can be powered by the included
power supply or through the Cat5e/6 cable using 2-way PoH (Power over HDBaseT). It also transmits Ethernet
through the same Cat5e/6 cable as well as IR and RS-232 signal to control a remote display or projector.

The VTX-T provides superior quality and reliability as well as these features:

• Support for high resolution video up to 4K.

• HDCP 2.2 Compliant, supporting HDMI 1.4.

• Utilizes HDBaseT 4-play technology for HDMI video, Ethernet pass-through, IR, and RS-232 control as well as
power over Cat5e/6 cable.

• Extends HDMI video at 1080p resolution up to 328ft (100m) and 4Kx2K up to 230ft (70m).

• One RS232 port for control of remote devices over HDBaseT.

• One infrared input and output for IR transmission over HDBaseT.

• Two 10/100 BaseT RJ45 ports for Ethernet pass-through.

• Ultra-slim design.

• 10.2Gbps bandwidth.

DECLARATION OF CONFORMITY (DOC)

The Declaration of Conformity for this product can be found on the RTI website at:
www.rticorp.com/declaration

Copyright © 2018 • Remote Technologies Incorporated • All rights reserved. 70-210174-22 V2.0

Touchscreen Control Panel

HDCPLINK

TX

1

2 3

RXTX

RS232 HDMI IN HDBT OUT ETHERNET ETHERNET DC 24V

1

4

2

3

5 6

7

VT X- T Transmitter

VTX-R Re ce iv er

RXTX

RXTX

4K 70 m

108 0P 100m

Lap top

IR Re ceive r

Rem ote

Pro jecto r

IR Em itter

Rou ter Lap top

HDM I:

RS2 32:

IR:

HDB aseT:

Int ernet :

It’s Under Control

®

Installation & Operation

FRONT PANEL DESCRIPTION

No. Name Function

1 LINK LED Indicator Turns blue when the transmitter and the receiver are connected successfully.

2 HDCP LED Indicator • Turns blue when the HDMI signal is transmitted with HDCP.

• Blinks blue when the HDMI signal is transmitted without HDCP.

• Turns o when there is no HDMI signal (no picture).

3 Power LED Indicator Turns red when power on.

CONNECTION DIAGRAM

REAR PANEL DESCRIPTION

No. Name Function

1 RS-232 3-pole captive screw connector for RS-232 pass-through control.

2 IR IN 3.5mm jack for connection to a control system IR output or IR receiver to collect IR signal.

3 IR OUT 3.5mm jack for connection to an IR emitter for control of external device. Works with VTX-R IR

4 HDMI IN Type A female HDMI input port to connect HDMI source device.

5 HDBT OUT RJ45 HDBaseT output port to connect to the HDBaseT input port of the receiver by CAT5e/

6 ETHERNET Two RJ45 ports, work as Ethernet Switch together with the Ethernet ports of transmitter or ma-

7 DC 24V Power port to connect the 24V DC power adapter.

It can be connected with control system (Use a 3-pole captive to 9 pin female D connector), or
connected with the device which needs to be controlled.

Works with VTX-R IR OUT

IN port.

CAT6a cable.

trix. Connect any one port with a router, the others are able to access LAN.

INSTALLATION

Please visit the RTI dealer portal (www.rticorp.com/dealer) for additional instructions and specications.
NOTE: Features and specications subject to change without notice.