RSVP APLR User Manual

1 2

11

lock

10

1. Prongs

2. Coring Blade

3. Peeling Blade

4. Peeling Blade Wingnut

5. Spindle

6. Spindle Release Lever

7. Handle

8. Suction Clamp Lever

9. Peeling Blade Lock

10. Coring Blade Wingnut

11. Slicing Blade

3

4

unlock

5 6

7

unlock

lock

CAUTION: BLADES ARE VERY SHARP. AVOID

DIRECT CONTACT WITH FINGERS AND HANDS.

KEEP OUT OF REACH OF CHILDREN.

89

This terrific tool, with its strong suction base and sharp blades, peels, cores and
slices apples rapidly with a simple turn of the handle. Versatile adjustments
allow you to make perfect 1/4" slices in one easy operation, greatly reducing
the preparation time for many dishes. You may also choose to use this tool to
peel only, or core and slice without peeling. For best results use only firm,

symmetrical fruit or potatoes. Please read through all the instructions to obtain
the best performance from your peeler.

CARING FOR THE APPLIANCE

HAND WASH ONLY. Lubricate the moving parts with vegetable oil to keep free
from corrosion, which can cause sticking.

GETTING STARTED

Set the peeler on an even, smooth countertop or cutting
board. Hold the peeler firmly at the round base and move the
suction clamp lever 8 to the lock position. Make sure the
clamp is securely suctioned to the surface before proceeding.

Make any of the following adjustments in preparation for use:

• Remove the protective cap from the prongs 1.

• Slide the spindle 5 back as far as it will go by pressing the
spring-loaded spindle release lever 6 and pulling the spindle
by the handle 7. NOTE: The prongs should pass through
the round coring blade 2. If the prongs cannot pass through

1

the coring blade, loosen the coring blade wingnut

11

and carefully adjust the coring blade unit

2

0

until the

prongs can pass through the center. Retighten the wingnut.

Use caution! Do NOT hold onto the slicing blade side 11
of the coring blade unit to adjust.

pEEl, coRE AND SlIcE

• Center the core of the apple in front of the prongs 1 and
push the stem end securely onto the prongs.

• Turn the handle 7 to begin the process.
NOTE: Adjust the peel thickness by loosening the peeling
blade wingnut 4 and sliding the peeling blade 3 forward
or back. Re-tighten the wingnut.

• Continue turning the handle 7 until the apple has

11

completely cleared the coring blade unit

2

. Remove the
sliced apple by pulling it away. Remove the core by pulling
it off the prongs 1.

pEEl oNly

•

Slide the spindle 5 back until the prongs 1 pass through

11

the coring blade unit

• Loosen the coring blade wingnut

11

blade unit

2

2

.

1

0

and rotate the coring

out of the way or remove it completely.

Use caution! Do NOT hold onto the slicing blade side 11
of the coring blade unit to adjust.

coRE AND SlIcE oNly

• Hold the spring-loaded peeling blade assembly 3 away
from the spindle 5.

• Flip the peeling blade lock 9 into the locked position.

R.S.V.P. International, Inc., Seattle, WA
www.rsvp-intl.com • © 2010

PEEL ONLY

APLR  01-2010