Rrs TA-3-QC, TA-2-QC User Manual
1146 Farmhouse Lane, San Luis Obispo, CA 93401 USA
1-805-528-6321 | 1-888-777-5557
www.ReallyRightStu.com
TA-3-QC ADDS 2½” - 15½” TO TRIPOD HEIGHT
TA-2-QC ADDS 2¼” - 12” TO TRIPOD HEIGHT
QUICK COLUMNS FOR VERSA TRIPODS
TA-3-QC FOR SERIES 3 / TA-2-QC FOR SERIES 2
TA-2-QC for Series 2
TA-3-QC for Series 3
SPECIFICATIONS:
Weight TA -3-QC / TA-2-QC.......................................12.7oz (361g) / 9.1oz (257)g
Length TA -3-QC / TA-2-QC......................................15” (381mm) / 12.25” (311mm)
Total Travel TA -3-QC / TA-2-QC.........................12.5” (318mm) / 9.4” (239mm)
Material.........................................................6061-T6 Aluminum
*TVC-33 tripods purchased prior to Oc tober 2010 cannot use TA-3- QC. Instead, buy quick column
model TA-3-QCH which includes the tripod platform and weight hook.
3/8” mounting hole accepts
Versa tripod platform.
Oversized butterfly knob for comfort and positive lock.
TA-3-QC OFFERS 12.5” OF TRAVEL
TA-2-QC OFFERS 9.4” OF TRAVEL
Lightest in Class 6061-T6 aluminum non-twist tube.
Threaded to accept Versa
weight hook.
MAINTENANCE
GENERAL CARE
The quick column is finished with a protective anodize plating that protects it from
corrosion and mild abrasion. It will not protect it from scraping or dropping on rocks/
concrete/etc. Take precautions to prevent your quick column from getting fouled in
mud, dirt, or sand, especially inside the butterfly knob.
CLEANING
Lightly rinse mud or salt water with fresh water and then thoroughly dry. If fine sand/
grit fouls the assembly, separate the quick column from the tripod, pull out the tube,
and rinse both under a gentle stream of water, then thoroughly dr y.
LUBRICATION
NO LUBRICATION IS REQUIRED BY THE USER. Just keep the components free from
contamination to maintain smooth action.
Remove Versa Platform & Hook
1
(A) Unscrew and remove Versa weight hook.
(B) Use a 1⁄8” hex key (included with Versa tripod) to
loosen, but not remove, all three SureGrip™ set
screws. NOTE: Expect some resistance when
loosening / tightening screws.
(C) Remove platform by pulling up.
C
B
A
Install Quick Column
2
(A) Insert Quick Column assembly into tripod apex. (B)
B
3
Make sure it is fully seated, then tighten all three
SureGrip™ set screws. (C) Reattach Versa weight
hook to bottom of tube.
Install Versa Platform
(A) Screw Versa tripod platform onto top
of column and hand tighten.
(B) Insert and hand tighten
included set screw.
B
A
GUARANTEE
ALL REALLY RIGHT STUFF BRAND PRODUCTS ARE GUAR ANTEED TO THE ORIGINAL
PURCHA SER TO BE FREE OF DEFEC TS IN MATERIALS OR WORKMANSHIP FOR
FIVE (5) YE ARS FROM THE DATE OF PURCHASE. PRODUCTS WILL BE REPAIRED OR
REPLACED AT OUR OPTION.
® , ™, © 1990-2017 Really Right Stuff, LLC. All rights reserved.
A
C
Loading...