RoyalDigital BS4100 Users Manual

*** USER’S MANUAL ***

FCC ID : SHBBS4100

The Federal Communication Commission Statement

This equipment has been tested and found to comply with the limits for a Class B Digital Device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction, may
cause harmful interference to radio communication. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of more of the following
measures: -

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

- Consult the dealer or an experienced Radio/TV technician for help.

Use only shielded cables to connect I/O devices to this equipment. You are cautioned that change
or modifications not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO
THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERECE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

1. This device may not cause harmful interference and

2. This device must accept any interference received, including interference that may cause
undesired operation.

Content

1. Product Introduction…………………………………………3

1.1 Overview………………………………………………………….3

1.2 Main Features…………………………………………………….3

1.3 Product Notification……………………………………………...3

1.4 Application………………………………………………………..3

2. Before Start…………………………………………………..4

2.1 LED Display…………………………………………………….4

2.2 Hardware Feature….…………………………………………....4

2.2.1 Power Switch…………………………………………….4

2.2.2 Power Jack………………………………………………4

2.2.3 Bluetooth Status LED (Blue)………………...………..4

2.2.4 GPS Status LED (Green)…………………….………..4

2.2.5 Battery Status LED (Red)……………………………..4

2.3 Getting Start….………………………………………………..5

2.3.1 Step 1: Power on wireless GPS receiver……………5

2.3.2 Step 2: Link to Bluetooth device……………………….5

2.3.3 Step 3: Navigate………………………………………..7

2.4 Fcc Notices…..………………………………………………….7

2