Royal Cozyfires MK4 - LPG User Manual

0102 095 52192

SHT Mk4 LPG

Super Hot Toaster Mk4

User, Installation & Servicing Instructions

This appliance is for use on PROPANE

Please hand this booklet to the user and advise to keep in a safe place

Important Notice: Before disposal of the outer packaging, please enter the product code, purchase and
installation details in section 1.1 of this booklet.

GAS (G31) ONLY at a supply pressure of 37mbar.

1 HM83 010710

This booklet details instructions for USER (section 1), INSTALLATION (section 2) & SERVICING (section 3).

IMPORTANT

It is important for the safe and continued operation of this appliance that the instructions contained in this booklet are
observed!

TABLE
Section 1.0 Instructions for Use

Section 2.0 Installation Instructions

Section 3.0 Maintenance and Servicing

NOTICE

OF CONTENTS

1.1 Record of purchase/installation

1.2 Important notes

1.3 Lighting and extinguishing the appliance

1.4 Re-laying the coal/pebble bed

1.5 Spare parts

1.6 Guarantee

2.1 Important notes

2.2 Statutory requirements

2.3 Technical data

2.4 Installing the appliance (Ventilation)

2.4.1 Flue

2.4.2 Clearance to sides and shelves

2.4.3 Hearth Clearances

2.4.4 Fitting the appliance in position

2.4.4.1 Connecting the gas supply

2.4.4.2 Restrictor Plate

2.4.4.3 Fitting the firebox in position

2.4.4.4 Checking the appliance setting pressure

2.4.4.5 Checking the correct operation

2.5 Laying the coal/pebble bed

2.6 Clearance of combustion products

2.7 Front and Frets (Requirements for ventilation)

2.8 Advising the customer

3.1 Removal of debris or soot

3.2 Servicing components below the heat engine

3.3 Spare parts

3.4 Useful telephone numbers

2 HM83 010710

Section 1 – Instructions for Use

A

1.1 RECORD OF PURCHASE/INSTALLATION Super Hot Toaster Mk4

Purchase Details

Date of purchase ______ / ______ / ______
Purchase from _____________________
Address _____________________
_________________________________________

Installation Details

Date of installation ______ / ______ / ______
Installed by _____________________
Registration number _____________________
Telephone number _____________________

ppliance Details

Serial number _____________________
(located on rating label)

Product Code _____________________
(located on white label on outer carton)

It is advisable to have all the above information
available if assistance is required. It will aid our
service department in helping you more efficiently.

3 HM83 010710

1.2 IMPORTANT NOTES Super Hot Toaster Mk4

 CAUTION – THIS PACKAGE WEIGHS 15Kgs – assess the load before you move it and note any other handling information

on the packaging. If you think the load is beyond your safe capability, DO NOT PUT YOURSELF AT RISK! Seek assistance
from other person(s) and/or use appropriate handling equipment. IT’S YOUR BODY – LOOK AFTER IT!

 This appliance is for DECORATIVE PURPOSES ONLY and is manufactured to the requirement s of t he current issue of EN 509.
 This appliance is for use on PROPANE GAS
 IN GREAT BRITAIN this appliance MUST
 Ventilation for this appliance must be fitted in accordance with the rules in force and checked regularly for obstructions.

If the appliance is installed in GREAT BRITAIN, additional ventilation is NOT normally required.
If the appliance is installed in IRELAND, a minimal cross sectional area of 100cm

 Any permanent flue restriction must be removed and any variable dampers locked fully open or removed. If the flue has been used

previously for solid fuel, it MUST be swept PRIOR to installation.

 If any soot accumulation becomes ex ce ssive, the fuel effect pieces should be removed from the appliance for cleaning. Cleaning

should be carried out in a sufficiently ventilated area or in the open air, by gently brushing with the pieces held away from your face so
that you avoid inhaling the dust. THE USE A NORMAL VACUUM CLEANER IS NOT RECOMMENDED as dust may be blown back
into the room.

 This appliance has a naked flame and a fireguard, to the current issue of BS 8423 – 2002, should be used for the protection of

children, the elderly and the inf i rm.

 Care must be taken on the selection of wall coverings within close proximity of the appliance as some vinyl and embossed mate rials

may become discoloured by convected heat. Soft furnishings must be kept clear from the radiant heat of the appliance and from
impinging the hearth area. Combustible materials must not be put on or left in the hearth area nor should the coal bed be used to burn
rubbish or other materials.

 This appliance uses fuel effect components, gaskets and insulation material containing Refractory Ceramic Fibre, (RCF), which are

man-made vitreous silicate fibre s. Excessive exposure to suc h material may cause temporary irritation to the eyes, skin and
respiratory tract. Co nsequently, it makes sense to take care when handlin g these articles to ensure that the release of dust is kept to a
minimum.

 This appliance is fitted with an ODS, a spillage monitoring system which oper at e s if the evacu at ion of prod u ct s is inte rrup ted (i.e.

blocked or incorrect flueing). If the appliance repeatedly `goes out’ it may indicate a problem and the installer or specialist should be
consulted before further use.

 The minimum temperature rating of any back panel or hearth must have a minimum fire resistance rating of CLASS 0 (100
 If any home improvements, e.g. double glazing, are carried out after this appliance has been installed, you should contact your

Registered Installer and have the operation of the flue checked.

1.3 LIGHTING AND EXTINGUISHING THE APPLIANCE

1. Remove the fret (Fig. 1), to gain access to the controls. (Fig. 2).

Fig. 1

2. Press and turn the gas control anti-clockwise to the `IGN’ position. Keep the con trol ful ly depressed.

3. Once the main burner is lit, keep the gas control depressed for a furth er 15 seconds.

4. Release the gas control and check that the main burner has remained alight.

5. Press and turn the gas control anti-clockwise to the required setting . Repla c e the fre t (controls cover).

6. To turn the appliance off, depress and turn the gas control clockwise from any position to the `OFF’ position.

7. In the event of the piezo ignition failing, the appliance may be lit by placing a lighted taper or match at the main burner while
depressing the gas control in the `IGN’ position.

IMPORTANT
After turning off or if the appliance goes out for any reason, wait for three minutes before attempting to relight.

(G31) ONLY, at a supply pressure of 37mbar +/- 1mbar.

be installed by a REGISTERED INSTALLER. Failure to do so may lead to prosecution.

2

is required.

o

C).

Fig. 2

Fret

Gas Control

4 HM83 010710

1.4 RE- LAYING THE COAL/PEBBLE BED Super Hot Toaster Mk4

Fig. 3

The support shelf is positioned on the fibre support
metalwork. There are two metal `stops’ that prevent
the support shelf from sitting on the main burner outlet
(Fig. 3).

Metal `stops’

Fig. 4

The simulated front is positioned on the shelf directly
in front of the support shelf. Two metal `stops’ locate the
simulated front in position.

Fit the two front retaining brackets with the two No 8x3/8 screws
supplied in the fixing pack to secure the front into position (Fig. 4).

Note: Large coals/pebbles (grey) and small coals/pebbles

(black) are coloured for illustration purposes only!

Metal `stops’

Fig. 5

Front Retaining Bracket

Place 5 large coals/pebbles on top of the simulated front (one in
each groove). Allow the coals/pebbles to rest on the support
shelf. Place 4 large coals/pebbles on the on the first tier of the
support shelf (Fig. 5).

Fig. 6

Place 6 small coals/pebbles
between the 5 large coals/pebbles
located on top of the simulated front.
Allow the coals/pebb les to rest on
the 4 large coals/pebbles on the first
tier.

Place 3 small coals/pebbles on top
of the 4 large coals/pebbles and
allow them to rest on the back tier of
the support shelf (Fig. 6).

Side View

To obtain the best visual appearance, it may be necessary to `slightly’ adjust the position of the coals.

5 HM83 010710

If any of the coals or coal bed become damaged or lost, replacements MUST be obtained before further use.

ADDITIONAL COALS/PEBBLES MUST NOT BE USED

1.5 SPARE PARTS Super Hot Toaster Mk4

For a list of spare parts for this appliance, please refer to section 3.3.

1.6 GUARANTEE

Please complete the registration section of the white card supplied in the IFU kit. Any part of this appliance is guarante ed against the
manufacturer’s defect ive workmanship or faulty materials for a period of twelve months from the date of purchase.

Any such part will be replaced free of charge on receipt of the purchaser’s address at the cost of postage only.
Please take time to fill in section 1.1 of this booklet for your future reference.

6 HM83 010710