Rowenta PROACTIVE 032621 - IC7100 - 50-03 User Manual
032621 - IC7100 - 50/03
instructions for use
1 • UNDERSTANDING YOUR IRONING CENTRE
14 15 1 3 5 7 6 4
12 11 13 9 8 10
2
1. Iron
2. Electric power cord (iron + board)
3. Steam cord
4. Steam cord support
5. Iron rest-plate
6. Removable water tank
7. Iron, power cord and steam cord storage
space
8. Control panel
9. Steam generator screw-clamps
10.Wheels (rubber-coated to protect delicate
floors)
11. Feet
12.Semi-automatic
opening lever (use only to
open the board)
13.Board closing and height adjuster lever
(use this lever to close the board)
14.Heated, active ironing area with ironing
board cover
15.Suction-blower unit
12 6 7
13
a) Control panel
Green "Steam
ready" light
Red "Water tank
empty" light
Steam output
control dial
Main ironing centre power On/Off (O/I)
switch (Controls board + generator)
RESTART button (Restarts heating of
the boiler during use)
b) Heated board with suction and blown-air functions
Board heats up automatically when the ironing centre
is switched on.
Suction function
Inside the board, the suction fan sucks air through the board.
Blown air function
Inside the board, the blower fan blows air through the board.
Board fan control button
suction
blown air
c) Iron
d) Steam generator
Steam cord
Soleplate temperature
control dial
Temperature
control light
Steam control
button
Humid steam
button
Screw-clamps
Boiler (inside compartment)
Rubber pads
Iron, power cord and steam cord
storage compartment catches
Cord outlets
ENG
2 • PREPARING YOUR IRONING CENTRE
1. Always place your ironing board on the floor in a horizontal position. (1)
2. Hold down the ironing board feet under one of your own feet. (2)
3. Use your hand to press the semi-automatic opening lever located underneath the front end of
the board, then raise the board to the required height (2).
4. If the board is too high for comfort, adjust its position using the adjuster lever (3).
5. Lift up and remove the water tank.
6. Unscrew the water tank cap.
7. Fill the water tank, taking care not to exceed the maximum level. (4)
8. Replace the cap on the water tank.
9. Replace the water tank in its housing, pressing down until it clicks into place (5).
98 cm
70 cm
Suitable water:
Your steam generator has been designed to operate using untreated tap water. However, if
your water is very hard, mix 50 % untreated tap water with 50 % distilled water.
The ironing centre comes with a tester that can be used to test the hardness of the water.
Unsuitable water:
Do not add anything to the contents of the removable water tank, and do not use water
from clothes-dryers, scented or softened water, water from refrigerators, batteries or air
conditioners, pure distilled water, pure demineralised water or rainwater, as these types of
water contain organic waste or mineral elements that become concentrated when heated
and cause spitting, brown staining or premature wear to the appliance.
(1)
(2)
(3)
(4)
(5)
3 • USING YOUR IRONING CENTRE
1.
Open the storage compartment cover by lifting the catches located on each
side of the iron rest-plate (6).
2.Remove the iron, steam cord and electric power cord from the storage compartment. (7)
3
.
Insert the power cord and steam cord in the cut-outs located on the sides of
the storage compartment. The ironing centre can be configured for left- or
right-handed use.
4
.
Close the storage compartment cover and place the iron on its rest-plate (8).
Warning : Your ironing centre is equipped with a safety device which cuts the power supply
when the iron is stored in its compartment.
To switch the iron on again, it is imperative that the iron is removed from its storage compartment first.
5. For maximum ironing comfort, fit the steam cord support in its mounting and feed the steam
cord through the support loop (9).
6. Connect the power cord to an earthed mains socket.
7. Switch on the main On/Off (O/I) switch (located on the control panel on the ironing board)
(10 - 1 ). The green light on the control panel will start to flash and the boiler will heat up
(10 - 2 ). When the green light stops flashing (after approximately 2 minutes), the steam supply
is ready.
When you switch on your ironing centre, the ironing board surface heats up automatically,
eliminating any risk of steam condensing. Your ironing board's surface will reach its operating
temperature in approximately 7 minutes.This does not prevent you from starting your ironing
as soon as the steam supply is ready (after 2 minutes).
• The first time you use your ironing centre, some fumes and a harmless smell may be released.
They will not affect use and will quickly disappear.
• After about a minute, and at regular intervals during use, your appliance's electric pump will
inject water into the boiler. It makes a noise, but this is quite normal.
2
1
(6)
(7) (8) (9) (10)
4 • OPERATING THE CONTROL PANEL
- Flashing green light: Water is heating in the boiler.
- Continuous green light: The steam supply is ready for use.
- Continuous red light: The water tank is empty.
- RESTART button: Press this button to restart boiler heating, whenever you have stopped to refill
the water tank (see chapter 9).
ENG
Loading...