Rowenta DW9210 User Manual [de]
www.rowenta.com
EN
DE
FR
NL
DA
NO
SV
FI
IT
ES
PT
EL
AR
DW9210
ECO INTELLIGENCE
a
b
c
ECO STEAM SYSTEM
1
2
3
SELF CLEAN
11
4
5
6
7
8
12
14
13
10
9
g.14g.13
g.12
g.11
g.10
OK
g.9
g.8
g.7
g.6
g.5b
g.5a
1 min.
g.4
g.3
g.2g.1
NO
g.22
NO
g.21
g.20
g.19
g.18
g.17g.16
g.15
2
EN
SAFETY INSTRUCTIONS
• Please read these instructions carefully and
keep them for further references.
• Never leave the appliance unattended when
it is connected to a power source; if it has not
cooled down for approximately 1 hour.
• The iron must be used and rested on a flat,
stable, heat-resistant surface.
• When you place the iron on the iron rest,
make sure that the surface on which you
place it is stable.
• Always unplug your appliance: before filling,
or rinsing the water tank, before cleaning it,
after each use.
• Children must be supervised to ensure that
they do not play with the appliance.
• Keep the iron and its cord out of reach of
children less than 8 years of age when it is
energized or cooling down.
• This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, if they have been given
supervision or instruction concerning use of
the appliance in a save way and understand
the hazards involved.
• Cleaning and user maintenance shall not be
made by children without supervision.
• The appliance must not be used if it has
fallen to the floor, shows evident of damage,
leaks or fails to function correctly. Never
dismantle you appliance. To avoid any
danger, have it inspected in an approved
service centre.
• The surfaces which are marked with this
sign and the soleplate are very hot
during the use of the appliances. Don’t
touch these surfaces before the iron is
cooled down.
IMPORTANT RECOMMANDATIONS
• The voltage of your electrical installation must correspond to that of the iron (220240V). Always plug your iron into an earth socket. Connecting to the wrong voltage
may cause irreversible damage to the iron and will invalidate the guarantee.
• If you are using a mains extension lead, ensure that it is corrected rated (16A) with
an earth, and is fully extended.
• If the electric power cord is damaged, it must be replaced by an Approved Service
Centre in order to prevent any danger.
• Do not unplug your appliance by pulling on the cord.
• Never immerse your steam iron in water or any other liquid. Never hold it under the
water tap.
• Never touch the electric cord with the soleplate of the iron.
• Your appliance gives off steam, which may cause burns, especially when you are
ironing close to the edge of your ironing board.
• Never direct the steam towards people or animals.
• For your saftey, this appliance conforms to the applicable standards and regulations
(Low Voltage, Electromagnetic Compatibility, Environmental Directives).
• This product has been designed for domestic use only. Any commercial use,
inappropriate use or failure to comply with the instructions, the manufacturer accepts
no responsibility and the guarantee will not apply.
ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials which can be recovered or
recycled.
Leave it at a local civic waste collection point.
Keep these instructions
3
DESCRIPTION
BEFORE USE
WARNING ! Remove any labels from the soleplate before heating up the iron.
WARNING ! Before using your iron with the steam function for the first time, we recommend
that you operate it in a horizontal position for a few moments, away from your linen, i.e. press
the Shot of Steam button a few times.
Upon the first use, you may notice small particles coming out of the soleplate. This is parf of
manufacturing process and is not harmful to you or your garments. It will disappear after
several uses. You may accelerate this by using the self cleaning function (fig 5a – 5b) and
shaking the iron gently.
1 • What water may be used ?
Your iron has been designed to operate using untreated tap water. If in doubt, check
with your local water authority. However, if your water is very hard, you can mix
50% untreated tap water with 50% distilled or demineralised water.
IMPORTANT Heat concentrates the elements contained in water during evaporation. The
types of water listed below contain organic waste or mineral elements that can cause
spitting, brown staining or premature wear of the appliance : water from clothes dryers,
scented or softened water, water from refrigerators, batteries or air conditioners, pure
distilled or demineralised water or rain water should not be used in your iron. Also do not use
boiled, filtered or bottled water.
IRONING BOARD: Due to the powerful steam output, a mesh type ironing board must be used
to allow any excess steam to escape and to avoid steam venting sideways.
1 Spray nozzle
2 Filling inlet
(with slide-button opening)
3 Eco steam system
a Dry ironing
b ECO position
C BOOST position
4 Shot of steam button
5 Cord
6 Handle
7 Thermostat control light
8 Spray trigger
9 Temperature control dial
10 Water tank
11 Self clean button
12 Maximum water level indicator
13 Soleplate
14 High Precision TIP
4
EN
USE
2 • Filling the water tank
IMPORTANT Before filling the water tank, unplug the iron and set the steam control to dry
position .
Tilt the iron. Open the filling inlet (fig.6). Pour in water up to the max mark (fig.7).
Close the filler inlet (fig.8) and return the iron to the horizontal.
3 • Temperature and steam adjustment
Set the iron temperature to suit the type of material using the temperature control
dial (fig.3).
Temperature control: The temperature control light indicates that the soleplate is
heating up. When the temperature control light goes off (fig.10), the set
temperature is reached and you can begin ironing.
IMPORTANT The iron takes longer to cool down than to heat up. We recommend that you start
with fabrics to be ironed at a low temperature.
For mixed fabrics set the temperature for the most delicate fabric.
TIP Always spray starch onto the reverse side of the fabric to be ironed.
4 • Dry ironing
Set the variable steam control to (fig.11) and set the temperature to suit the
type of material (care points •, ••, •••).
5 • Eco steam system
Your Steam Iron is equipped with the Eco Steam System. This function offers 3 steam
settings for optimal ironing:
- DRY position: For an ironing without steam, ideal for delicates or perfect finishes.
- ECO position: For an optimized ironing with a steam output perfectly adapted to all
fabric types. This setting ensures qualitative ironing results while saving energy.
- BOOST position: For increased variable steam output to reach perfect result on
thickest fabrics.
6 • Shot of steam
(from temperature setting •• upwards)
Press the shot of steam button to generate a powerful jet of steam (fig.16).
Wait a few seconds between each shot before pressing the button again.
7 • Vertical shot of steam
(from temperature setting •• upwards)
TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning delicate fabrics.
Hold the iron to the vertical and press the shot of steam button ( fig.17) to remove
creases from suits, jackets, skirts, hanging curtains etc.
Wait a few seconds between each shot before pressing the button again.
IMPORTANT Never direct the steam at persons or animals!
8 • Spray
Press the spray button to dampen stubborn creases (fig.18).
9 • Anti-Drip system
This prevents water escaping from the soleplate when the temperature is too low.
ECO STEAM
Coton,
lin
Soie, laine
Nylon
Loading...