Rough Country 1169 User Manual

92116900

TJ \ YJ D-RING MOUNT

Thank you for choosing Rough Country

Please read instructions before beginning installation. Check the kit hardware against the parts list and product
layout. Be sure you have all needed parts and know where they go. Also please review tools needed list and make
sure you have needed tools.

If questions exist we will be happy to answer any questions concerning the design, function, and correct use of this
product.

Kit Contents:

2-D-ring mounts
2-D-rings
4-1/2” X 1 3/4” Bolts
4– 1/2 Washers

Tools Needed:

T-55 torx bit / rachet
3/4”-socket

TJ INSTALLATION INSTRUCTIONS

1. Remove the factory hardware and factory hook if equipped using a T-55 torx head bit that secures the
bumper to the front frame rails as shown in Figure 1. TJ installation shown. The rear holes in the d-ring
bracket will not be used on the TJ application.

2. On the TJ using the supplied 1/2” x 1 3/4” hardware, install the d-ring mount in the 2 factory holes as shown
in Figure 2. Installation shown using factory bumper.

3. Tighten hardware to 65 ft/lbs specs.

4. Repeat for opposite side.

5. Install d-ring as shown in Figure 3.

FIGURE 1 FIGURE 2

FIGURE 3

YJ INSTALLATION INSTRUCTIONS

1. Remove the factory hardware using the T-55 torx head bit that secures the bumper to the front frame rails as
on the TJ. The center holes in the d-ring bracket will not

2. If using this kit with a factory bumper, you will have to trim the plastic frame cover to expose the 2 rear holes.
If used with the Rough Country winch mount or aftermarket winch mount the bracket will install on top of the
winch mount and no trimming will be required but a longer bolt may be required to accommodate the extra
thickness of the winch plate.

3. On the YJ using the supplied 1/2 x 1 3/4” hardware, install the d-ring mount in the 2 factory holes. Tighten
hardware to 65 ft/lbs.

4. Install d-ring as shown in Figure 3.

be used on the YJ application.