Rough Country 1124 User Manual
92112400
JEEP JK REAR BUMPER BRACKETS
FOR USE WITH VEHICLES EQUIPPED WITH 1 1/4” BODY LIFT
Thank you for choosing Rough Country for your suspension needs.
This kit is for use with vehicles equipped with a 1 1/4” body lift to return the rear bumper to the stock loca-
tion.
In addition to these instructions, professional knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
tion. Check the kit hardware against the kit contents. Be sure you have all the needed parts and understand where
they go. Also please review the tools needed list and make sure you have needed tools. If you have any questions
please call us at 800-222-7023.
Please read all the instructions before beginning the installa-
KIT CONTENTS:
2-Inner brackets
1-Driver side bracket
1-Pass side bracket
TOOLS NEEDED:
16mm Socket
INSTALLATION INSTRUCTIONS
1. Remove the stock bumper brackets from the frame rail and the bumper as shown in Photo 1 & 2 using a 16mm
socket.
Photo 1 Photo 2
2. Remove the inner brackets from the frame rail as shown in Photo 3 from the driver and passenger side. Retain
the hardware for reuse.
3. Remove the stock bumper from the vehicle.
4. Install the inner bumper brackets on the bumper as shown in Photo 4 using stock hardware. Do not tighten at this
time.
Photo 3 Photo 4
5. Install the bumper on the frame and install the outer bumper brackets with the stock hardware. Do not tighten at
this time. See Photo 5.
6. Align the bumper and tighten all hardware with a 16mm socket. See Photo 6.
Photo 5 Photo 6
POST INSTALLATION
• All components must be retightened after 500 miles, and every three thousand miles after installation.
Thank You for using Rough Country for your off road vehicle needs
Loading...