Rough Country 1113 User Manual

92111300

JEEP JK REAR COIL ANGLE SHIM KIT

Thank you for choosing Rough Country for your suspension needs.

In addition to these instructions, professional knowledge of disassemble/reassembly procedures as well as post installa­tion checks must be known. Attempts to install this system without this knowledge and expertise may jeopardize the
integrity and/or operating safety of the vehicle.

PRODUCT USE INFORMATION

Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re­sponsible for any product that is altered.

If question exist we will be happy to answer any questions concerning the design, function, and correct use of our prod­ucts by calling 1-800-222-7023.

NOTICE TO DEALER AND VEHICLE OWNER

Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehi­cle of its unique handling characteristics. INSTALLING DEALER - it is your responsibility to install the warning decal and
forward these installation instructions on to the vehicle owner for review. These instructions should be kept in the vehicle
for its service.

This kit is intended to be used with 3.5”-6” kits to correct the rear coil angle.

Kit Contents:

Coil Spacer (2)

Thank you for choosing Rough Country for your suspension needs.

INSTALLATION INSTRUCTIONS

1. Chock front wheels. Jack up the rear of the vehicle and support the vehicle with jack stands, so that the rear whe els
are off the ground.

2. Remove the rear tires/wheels

Position a jack so it supports, but does not raise the rear axle.

, using a 19mm deep well socket.

3. The next steps are performed to ensure sufficient travel to remove the coil springs

4. On the rear of the vehicle remove the factory sway bar link from the axle using a 18mm socket and wrench. Retain
hardware for reuse.

5. Using a 10mm wrench, unbolt the brake hose bracket at the frame. Retain hardware for later use. See Photo 1.

6. Remove the rear shocks from the lower mount using a 18mm wrench. Retain stock h a rdware.

7. Lower the axle enough to remove the stock coil springs.

8. Install the spacer on the stock coil seat as shown in Photo 2.

PHOTO 1

9. Install the coil spring as shown in Photo 3.

10. Reinstall the factory sway bar link using a 18mm socket
and wrench on the axle.

11. Reinstall the brake hose bracket in the stock location us­ing a 10mm wrench.

12. Reinstall the rear shocks on the axle mount using a
18mm wrench.

13. Reinstall the tires and wheels and lower to the ground.

Also available for the rear of the JK Jeep is a Coil Retainer kit. Part # 1132.

PHOTO 2

PHOTO 3

POST INSTALLATION

• Check all fasteners for proper torque. Re-torque all fasteners after 500 miles an d recheck

after 1000 miles.