Rough Country 1106 User Manual

92110600

JEEP JK FRONT ARM RELOCATION KIT

Thank you for choosing Rough Country for your suspension needs.

Rough Country recommends a certified technician install this kit. In addition to these instructions, professional knowl­edge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install this
product without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.

Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you have all
needed parts and know where they go. Also please review tools needed list and make sure you have needed tools.

Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re­sponsible for any product that is altered. If question exist we will be happy to answer any questions concerning the de­sign, function, and correct use of our products by calling 1-800-222-7023.

IMPORTANT NOTE : Upon completing the install of this kit the draglink must be adjusted to center the
steering wheel BEFORE
dling, and poor performance.

Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehi­cle of its unique handling characteristics.

INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on
to the vehicle owner for review. These instructions should be kept in the vehicle for its service life.

the vehicle is driven. Failure to do so will cause a computer error, odd han-

NOTICE TO DEALER AND VEHICLE OWNER

PRODUCT USE INFORMATION

Tools Needed:

Jack Stands

Floor Jack

Reciprocating Saw
18mm Socket / Wrench
19mm Socket / Wrench
21mm Socket / Wrench
22mm Socket / Wrench

INSTALLATION INSTRUCTIONS

1. Chock the rear wheels.

2. Jack up the front of the vehicle and support with jack stands on the frame just rearward of the lower co ntrol arm
mounts.

3. Place a jack under the axle and lightly support the weigh of the axle.

4. On 2012 models the heat shield on the passenger side upper arm will need to be removed. The heat shield will not
be reused. Remove shield at this time.

5. Loosen the upper control arm bolt on the frame and from the axle using a 18mm wrench. See Photo 1. Retain the
axle hardware as it will be reused.

6. To remove the upper control arm the frame bolt must be cut. See Photo 2. Cut the bolt as shown.

Photo 1

Photo 2

LOOSEN THE UPPER ARM HARDWARE CUT THE UPPER BOLT

7. Loosen and remove the lower control arm hardware from the axle and frame using a 21mm wrench. Retain the fac­tory hardware. See Photo 3.

8. Remove the upper and lower control arms from the vehicle. See Photo 4.

Photo 3

Photo 4

LOOSEN THE LOWER ARM HARDWARE

REMOVE THE ARMS

9. Place the outer frame bracket as shown on the frame mounts as shown in Photo 5.

10. Install the inner frame bracket with the supplied crush sleeves and secure with the 14mm x 110mm bolt, washers
and lock nut on the lower mount and the supplied 12mm x 90mm bolt, washers and flange lock nut on the upper
mount. Do not tighten at this time. See Photo 6. The bracket with the slot is the inner bracket.

Photo 5

Photo 6

PLACE THE OUTER BRAKET IN MOUNTS PLACE THE INNER BRACKET AND SECURE