Rough Country 1096 User Manual
92109600
1/4” WHEEL SPACER KIT FOR 5-5.5” WHEEL PATTERN
Thank you for choosing Rough Country for all your suspension needs.
Professional knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install these wheel spacers without this knowledge and expertise may jeopardize the integrity and/or operating
safety of the vehicle.
Please read instructions before beginning installation. Also please review tools needed list and make sure you have
needed tools.
Important Note: Spacers must be periodically checked to ensure tightness.
Kit Contents:
Part #1096 Qty 2-1/4”” Wheel Spacers
Tools Needed:
Torque Wrench
Floor Jack
Jack Stands
Sockets
Socket wrench
Installation Instructions
1. Chock the tires and jack up the vehicle.
2. Remove the lug nuts and remove the tire and wheel. If
retaining clips are present they must be removed for the
spacer to sit flat on the rotor surface. Note: Failure to
remove the factory retaining clips on the wheel studs
could result in a wheel /tire vibration.
3. Install the wheel spacers as shown. See Photo 3.
4. Reinstall the wheels and tighten to manufacturer specifications using a 19mm wrench. DO NOT EXCEED MANU-
FACTURER SPECIFICATIONS.
Post Installation
• Wheels must be re-torqued periodically. Visually inspect components and re torque
fasteners during routine vehicle service.
Photo 1
Loading...