Rough Country 1062 User Manual
92105900
JEEP JK MODULAR WINCH MOUNT
Thank you for choosing Rough Country for all your suspension needs.
Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you have all
needed parts and know where they go. Also please review tools needed list and make sure you have needed tools.
Please read instructions before beginning installation. Check the kit hardware against the parts list and product layout.
Be sure you have all needed parts and know where they go. Also please review tools needed list and make sure you
have needed tools.
If questions exist we will be happy to answer any questions concerning the function and correct use of this product.
The installer must verify that the mounting kit does not interfere with the factory air bag sensors, which must not be relo-
cated or modified in any way. The vehicles air bag system may not operate properly if the winch mounting kit is not
mounted in compliance with the vehicle manufacturers recommendations.
PRODUCT USE INFORMATION
Tools Needed:
3/4” Socket / Wrench
8mm Allen Head Bit / Wrench
18mm Socket / Wrench
Phillips Screwdriver
Part#1062 Kit with Light
Mount caps & Plate
Kit Contents:
1059-Winch Mount w/ Caps:
Winch Mount
1-Dr Side Cap
1-Pass Side Cap
2-Flag Nuts
OR
1062-Winch Mount w/ Light End
Caps:
Winch Mount
1-Dr Side Cap w/ Light Mount
1-Pass Side Cap w/Light Mount
1-Poly Bag
Part#1059 Kit with
caps & Plate
1059BAG1-End Caps
8-1/2” x 1 1/2” Allen Head Bolts
2-1/2” x 1 1/2” Bolts
10-1/2” Flat Washers
8-1/2” Lock Nuts
2-Flag Nuts
OR
1062BAG-Light Mount Caps
8-1/2” x 1 1/2” Allen Head Bolts
2-1/2” x 1 1/2” Bolts
10-1/2” Flat Washers
8-1/2” Lock Nuts
2-Flag Nuts
8-#10 X 24 Nut
INSTALLATION INSTRUCTIONS
1. Place vehicle on a flat surface and set emergency brake.
2. Using a small phillips screwdriver, remove the 2 plastic screws on top of the front bumper cover. See Photo 1.
3. Remove the 4 plastic screws holding the skid plate to the front bumper, using a small Phillips screw driver. See
Photo 2.
Photo 1
REMOVE BUMPER COVER HARDWARE
4. Using a 18mm socket, remove the 4 bolts holding the bumper to the frame horn on the driver and passenger side.
See Photo 3.
5. Find the plug for the fog lights if equipped and unplug. See Photo 4.
Photo 3
Photo 2
REMOVE BUMPER COVER HARDWARE
Photo 4
REMOVE BUMPER HARDWARE
6. Remove Bumper.
7. Remove the stock tow hook brackets if equipped.
8. Installation of the roller fairlead / hawse lead and winch on the winch plate is performed next in order to ease installation.
9. Install the roller fairlead / hawse lead with the appropriate hardware that was included with the winch and tighten.
See Photo 5.
10. Install the cable through the fairlead and install hook.
11. Install the winch on the winch plate with the hardware that was included with the winch and tighten. Bottom of winch
plate pictured. See Photo 6.
Photo 5 Photo 6
INSTALL ROLLER FAIRLEAD INSTALL WINCH ON PLATE
REMOVE BUMPER COVER HARDWARE REMOVE BUMPER COVER HARDWARE
Loading...