Rough Country 1057 User Manual

92105700

JEEP XJ WINCH BUMPER

Thank you for choosing Rough Country for all your suspension needs.

Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you have all
needed parts and know where they go. Also please review tools needed list and make sure you have needed tools.

Please read instructions before beginning installation. Check the kit hardware against the parts list and product layout.
Be sure you have all needed parts and know where they go. Also please review tools needed list and make sure you
have needed tools.

If questions exist we will be happy to answer any questions concerning the function and correct use of this product.
The installer must verify that the mounting kit does not interfere with the factory air bag sensors, which must not be relo-

cated or modified in any way. The vehicles air bag system may not operate properly if the winch mounting kit is not
mounted in compliance with the vehicle manufacturers recommendations.

Optional Accessories are available for the Rough Country winch bumper including: See back page for info:

Part # 1056...Light Bar / Winch Guard

PRODUCT USE INFORMATION

Part # 1055...Stinger

Part # 1058...D-Ring Kit

Kit Contents:

1057Box1
Bumper
1057Box2
Winch Plate
Frame Brackets
1057BAG1­ 22-1/2” x 1 1/2” Bolt
22-1/2” Lock nuts
44-1/2” Flat Washers
4-7/16” x 4” Bolts
4-7/16” x 1 1/4” Bolts
14-7/16” Flat Washers
6-7/16” Lock Nuts
2-10mm x 35mm
2-10mm Flat Washers
2-12mm x 35mm Bolts
2-12mm Flange Lock nuts
1057BAG3-Accessrory Hardware Bag
14-1/2” X 1 1/2” Allen Head Bolts
14-Lock Nuts

Tools Needed:

9/16” Socket/ Wrench
3/4” Socket / Wrench
Drill Motor
15/32” Drill Bit
T30 Torx Head Bit
T55 Torx head
5/16” Allen Head Wrench
Rachet

INSTALLATION INSTRUCTIONS

1. Place vehicle on a flat surface and set emergency brake.

2. Remove the front bumper end caps as shown in Photo 1 & Photo 2 using a 10mm wrench and rem ove the cap from
the bumper.

Photo 1 Photo 2

Remove bumper caps Remove bumper caps

3. Remove the bumper as shown in Photo 3 by removing the bolts using a T30 torx head bit wrench.

4. Remove the bumper bolts ( three per side) as shown in Photo 4 from the uni-body using a 15mm socket.

Photo 3

Photo 4

Remove bumper hardware

5. Remove the rear most bumper bolt from the uni-body using a T55 torx bit. See Photo 5.

6. Remove the bumper from the vehicle.

7. Install the bumper bracket on the frame as shown with the 7/16” x 4” bolts, washers and lock nuts on the driver side.

See Photo 6. Do not tighten until all bolts have been installed.

Photo 5

Remove bumper brackets

Remove bumper hardware

Photo 6

Install 7/16” x 4” bolts / hardware