Rough Country 1046 User Manual
92104600
(FOR USE WITH ROUGH COUNTRY WINCH PLATE PART #1059)
JEEP JK D-RING KIT
Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Be sure you have all needed parts and know where they go.
Please review tools needed list and make sure you have needed tools.
PRODUCT USE INFORMATION
This part #1046 is for use with the Rough Country JK winch plate, part #1059. These mounts are installed with the hardware that is included with the 1059 kit.
If question exist we will be happy to answer any questions concerning the design, function, and correct use of our products by calling 1-800-222-7023.
8mm Allen Head Bit / Wrench
Tools Needed:
INSTALLATION INSTRUCTIONS
1. Install the d-ring mount on the front of the winch plate as shown in Photo 1 with the supplied 1/2” x 1 1/2” button
head bolts that were included with the 1059 winch plate.
2. Tighten the mounts using a 8mm allen head bit.
3. Install the d-rings in the mount with the supplied washers and snug the cross pin. See Photo 2.
POST INSTALLATION INSTRUCTIONS
• All hardware must be checked periodically to ensure all fasteners are tight.
Loading...