Rough Country 1031 User Manual

92103100

97-06 JEEP TJ 7” FLARE KIT

Thank you for choosing Rough Country for all your suspension needs.

Please read instructions before beginning installation. Check the kit hardware against the parts list on this page.
Be sure you have all needed parts and know where they go. Also please review tools needed list and make
sure you have needed tools.

Rear Driver Flare
Rear Pass Flare
Front Driver Flare
Front Driver Lower Flare
Front Pass Flare
Front Pass Lower Flare
1-Hardware Bag

1. Starting on the rear, remove the plastic trim retainer as shown holding the inner fender skirting in place on

2. Remove the plastic debris flap hardware as shown using a 8mm & 11mm socket and remove the flap. Re-

Kit Contents:

REAR INSTALLATION INSTRUCTIONS

the front of the rear fender well.
tain hardware.

Tools Needed:

Pliers

8MM Socket / Wrench
10mm Socket / Wrench
11MM Socket / Wrench

PHOTO 1 PHOTO 2

REMOVE THE PLASTIC RETAINER

11mm

8mm

3. Remove the inner fender wheel well plastic allowing access to the plastic flare retainers. See Photo 3.

4. Remove the all hardware securing the stock flare to the body using a 8mm wrench. See Photo 4.

PHOTO 3

REMOVE THE INNER FENDER PLASTIC REMOVE THE STOCK HARDWARE

5. Remove the stock flare from the Jeep. Locate the appropriate flare and install using the supplied hardware.
Tighten using a 8mm wrench. Slightly snug the hardware. Do not over-tighten the hardware. See Photo 5.

6. Reinstall the plastic inner fender well with the stock hardware and reinstall the plastic trim retainer. The rear
plastic debris flap can be reinstalled if desired. See Photo 6.

PHOTO 5 PHOTO 6

PHOTO 4

INSTALL THE SUPPLIED HARDWARE

REINSTALL THE PLASTIC RETAINER