Rough Country 1010 User Manual

92101000

09-UP FORD F150 WINCH PLATE

THANK YOU FOR CHOOSING ROUGH COUNTRY FOR YOUR OFF ROAD NEEDS.

Rough Country recommends a certified technician install this kit. In addition to these instructions, professional knowl­edge of disassemble/reassembly procedures as well as post installation che cks must be known. Attempts to install this
kit without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.

Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you have
all needed parts and know where they go. Also please review tools needed list and make sure you have needed tools.

Does not fit the eco-boost models

Install winch with instructions supplied with winch. Always practice safe winching and recovery. Never overload a winch
or use the winch which in any way would void your manufactures warranty.

PRODUCT USE INFORMATION

Tools Needed:

10mm wrench /socket
15mm wrench /socket
16mm wrench /socket
3/8” Wrench
3/4” Wrench

Reciprocating Saw

Or

Body Sway

Kit Contents:

1010 Box Contains:

Winch Plate
Fairlead Bracket
Control Box Bracket
2-Flag Nuts

1010 Poly Bag:
2-1/2” x 1.5” Bolts

2-1/2” Flat Washers
2-3/8” X 1 1/4 Bolts
2-3/8” Lock Nuts
2-6mm x 16mm Bolts
2-16mm Lock Nuts
2-1/4” x 3/4” Bolts
2-1/4” Lock Nuts

1. Remove the tow hooks using a 15mm socket. Retain the hardware for reuse. See Photo 1.

2. Remove the rubber lower shield by removing the push in retainers from inside the bumper. See Photo 2.

PHOTO 1 PHOTO 2

REMOVE TOW HOOKS REMOVE THE LOWER RUBBER SHIELD

3. Place winch plate in place and hold in place with the tow hook bolts. See Photo 3.

4. Trim the plastic as needed to install the plate. See Photo 4.

PHOTO 3 PHOTO 4

PLACE WINCH PLATE ON MOUNTS TRIM PLASTIC AS NEEDED

5. Reinstall the tow hooks with the factory hardware. See Photo 5.

6. Place the supplied flag nut in the frame as shown in Photo 6 and install the supplied 1/2” X 1 1/2” bolts and flat
washers. Tighten using a 3/4” wrench.

PHOTO 5 PHOTO 6

REINSTALL THE TOW HOOKS INSTALL FLAG NUT AND 1/2” X 1 1/2 BOLT