Rotel RX-1052 Owners manual
Owner’s Manual
RX-1052
AM/FM Stereo Receiver
STANDBY ZONE
TUNING
A
TUNE/
PRESET MEMORYMONO
B
AM/FM STEREO RECEIVER RX-1052
TREBLE
BANDSPEAKERS
BASS
PHONO CD TUNER VIDEO1TAPE
VIDEO2 SELZONEVIDEO4VIDEO3
> 10 cm
> 4 in
> 10 cm
> 4 in
> 10 cm
> 4 in
> 10 cm > 4 in
VIDEO2 SELZONEVIDEO4VIDEO3
AM/FM STEREO RECEIVER RX-1052
STANDBY
PHONO CD TUNER VIDEO1TAPE
TUNE/
PRESET MEMORYMONO
TUNING
BANDSPEAKERS
A
B
BASS
TREBLE
Notice
Important Safety Instructions
The COMPUTER I/O connection should be handled by authorized person
only.
FCC Information
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.(TV, radio, etc.)
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for additional
help.
Caution
This device complies with part 15 of the FCC Rules operation is subject to
the following to conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna
installer’s attention to Article 820-40 of the NEC. This provides guidelines
for proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as close to the
point of cable entry as practical. See installation diagram.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against interference
in a residential installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause interference to radio or TV communications. There
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the unit and the television tuner.
• Connect the unit to an AC power outlet on a different electrical circuit.
• Consult your authorized Rotel retailer for assistance.
WARNING: There are no user serviceable parts inside. Refer all servicing to qualified service personnel.
WARNING: To reduce the risk of fire or electric shock, do not expose the
unit to moisture or water. Do not allow foreign objects to get into the enclosure. If the unit is exposed to moisture, or a foreign object gets into the
enclosure, immediately disconnect the power cord from the wall. Take the
unit to a qualified service person for inspection and necessary repairs.
Read all the instructions before connecting or operating the component.
Keep this manual so you can refer to these safety instructions.
Heed all warnings and safety information in these instructions and on the
product itself. Follow all operating instructions.
Clean the enclosure only with a dry cloth or a vacuum cleaner.
Do not use this unit near water.
You must allow a minimum 10 cm or 4 inches of unobstructed
clearance around the unit. Do not place the unit on a bed, sofa, rug,
or similar surface that could block the ventilation openings. If the unit is
placed in a bookcase or cabinet, there must be ventilation of the cabinet to
allow proper cooling.
Keep the component away from radiators, heat registers, stoves, or any
other appliance that produces heat.
The unit must be connected to a power supply only of the type and voltage
specified on the rear panel. (USA: 115 V/60Hz, EC: 230V/50Hz)
Connect the component to the power outlet only with the supplied power
supply cable or an exact equivalent. Do not modify the supplied cable. Do
not defeat grounding and/or polarization safety provisions. A polarized
plug has two blades, with one wider than the other. A grounding plug has
two blades plus a third grounding prong. These are provided for your safety.
If the supplied plug does not fit your outlet, please consult an electrician for
replacement of the obsolete outlet. Do not use extension cords.
The main plug of the power cordset is a disconnect device of the apparatus. In order to completely disconnect the apparatus from the supply mains,
the main plug of the power cordset should be unplugged from the mains
(AC) outlet. The stand-by LED indicator will not be lit up to show the power
cord is unplugged.
Do not route the power cord where it will be crushed, pinched, bent, exposed to heat, or damaged in any way. Pay particular attention to the power
cord at the plug and where the cord exits the back of the unit.
The power cord should be unplugged from the wall outlet during a lightning storm or if the unit is to be left unused for a long period of time.
Use only accessories specified by the manufacturer.
Use only with a cart, stand, rack, bracket or shelf system recommended by
Rotel. Use caution when moving the unit in a stand or rack to avoid injury
from a tip-over.
Immediately stop using the component and have it inspected and/or serviced by a qualified service agency if:
• The power supply cord or plug has been damaged.
• Objects have fallen or liquid has been spilled into the unit.
• The unit has been exposed to rain.
• The unit shows signs of improper operation
• The unit has been dropped or damaged in any way
RX-1052 AM/FM Stereo Receiver
1: Controls and Connections
4
English
TREBLE
BASS
621
AM/FM STEREO RECEIVER RX-1052
13
14
7
PHONO CD TUNER VIDEO1TAPE
VIDEO2 SELZONEVIDEO4VIDEO3
15 16
STANDBY ZONE
8
A
B
9
43 5
TUNING
TUNE/
PRESET MEMORYMONO
10 11 12
BANDSPEAKERS
17 18 21 222019 2523 24
ANTENNA
GND
AM
LOOP
ZONE 3
ZONE 2
L
R
ZONE 4
OUT
OUT
OUT
ZONE 2
ZONE 3 ZONE 4
12V TRIG OUT
PHONO
L
R
IR IN
CD
EXT
REM
ALL
TAPE
IN OUT
IR
OUT
AM/FM STEREO RECEIVER
1
MODEL NO. : RX-1052
POWER CONSUMPTION: 300 WATTS
2
VIDEO 1 VIDEO 3 VIDEO 4
IN OUT
VIDEO 2
IN OUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
MON
OUT
SOFTWARE
COMPUTER
UPGRADABLE
I/O
RIGHT LEFT
A
SPEAKERS
B
RIGHT LEFT
SPEAKER IMPEDANCE MINIMUM
A OR B 4 OHMS PER SPEAKER
A AND B 8 OHMS PER SPEAKER
POWER
ON
OFF
27 292826 30 31 35 36 3732 33 34
5
GND
AM/F
M
POWER C
PHONO
IN OUT
TAPE
IN
VIDEO
ZONE 4
OUT
ZONE 3
OUT
ZONE 2
OUT
CD
ZONE 3 ZONE 4
ALL
EXT
REM
2
1
ZONE 2
12V TRIG OUT
IR IN
IR
OUT
L
R
L
R
AM
LOOP
ANTENNA
2: RR-AT93 Remote Control 3: Antenna Connections
English
A
OFF
RR-AT93
ON
123
VOLUME
J
456
B
7
0
89
10 +10
C
D
E
F
G
H
T/P
DIRECT BAND
LABEL ENTER CHARACTER
A
B REC DISP
SPEAKERS
MUTE
TUNING
+
-
K
L
M
N
O
P
PH CD TUN TP
I
V1 V2 V3 V4
INPUTS
RX-1052 AM/FM Stereo Receiver
4: Speaker and TV
6
English
AUDIO OUTPUTS
RIGHT LEFT
ANTENNA
GND
AM
LOOP
ZONE 4
ZONE 3
L
R
ZONE 2
OUT
OUT
OUT
ZONE 2
ZONE 3 ZONE 4
12V TRIG OUT
PHONO
L
R
IR IN
CD
EXT
REM
ALL
TAPE
IN OUT
IR
OUT
AM/FM STEREO RECEIVER
1
MODEL NO. : RX-1052
POWER CONSUMPTION: 300 WATTS
2
VIDEO 1 VIDEO 3 VIDEO 4
IN OUT
VIDEO 2
IN OUT
VIDEO INPUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
MON
OUT
COMPUTER
I/O
SOFTWARE
UPGRADABLE
RIGHT LEFT
A
SPEAKERS
B
RIGHT LEFT
SPEAKER IMPEDANCE MINIMUM
A OR B 4 OHMS PER SPEAKER
A AND B 8 OHMS PER SPEAKER
POWER
ON
OFF
5: CD and Phono
7
English
ANTENNA
ZONE 2
IR IN
ZONE 3 ZONE 4
GND
AM
LOOP
ZONE 3
ZONE 2
L
R
ZONE 4
OUT
OUT
OUT
PHONO
L
R
12V TRIG OUT
CD
EXT
REM
ALL
TAPE
IN OUT
IR
OUT
AM/FM STEREO RECEIVER
1
MODEL NO. : RX-1052
POWER CONSUMPTION: 300 WATTS
2
VIDEO 1 VIDEO 3 VIDEO 4
IN OUT
VIDEO 2
IN OUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
MON
OUT
SOFTWARE
COMPUTER
UPGRADABLE
I/O
RIGHT LEFT
A
SPEAKERS
B
RIGHT LEFT
SPEAKER IMPEDANCE MINIMUM
A OR B 4 OHMS PER SPEAKER
A AND B 8 OHMS PER SPEAKER
POWER
ON
OFF
RIGHT LEFT
ANALOG OUTPUTS
6: Tape
ANTENNA
AM
LOOP
L
R
ZONE 2
OUT
GND
ZONE 3
OUT
RIGHT LEFT
LINE OUT
ZONE 4
OUT
ZONE 2
L
R
AUDIO
IR IN
ZONE 3 ZONE 4
12V TRIG OUT
PHONO
CD
RIGHT LEFT
REC IN
EXT
REM
ALL
TAPE
IN OUT
IR
OUT
AM/FM STEREO RECEIVER
1
MODEL NO. : RX-1052
POWER CONSUMPTION: 300 WATTS
2
VIDEO 1 VIDEO 3 VIDEO 4
IN OUT
VIDEO 2
IN OUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
MON
OUT
SOFTWARE
COMPUTER
UPGRADABLE
I/O
RIGHT LEFT
A
SPEAKERS
B
RIGHT LEFT
SPEAKER IMPEDANCE MINIMUM
A OR B 4 OHMS PER SPEAKER
A AND B 8 OHMS PER SPEAKER
POWER
ON
OFF
RX-1052 AM/FM Stereo Receiver
7: DVD and SAT/CABLE/HDTV
8
ANTENNA
ZONE 2
IR IN
ZONE 3 ZONE 4
GND
AM
LOOP
ZONE 4
ZONE 3
L
R
ZONE 2
OUT
OUT
OUT
PHONO
L
R
12V TRIG OUT
CD
REM
OUTPUTS
EXT
ALL
TAPE
IN OUT
RIGHT LEFT
AUDIOVIDEO
IR
OUT
AM/FM STEREO RECEIVER
1
MODEL NO. : RX-1052
POWER CONSUMPTION: 300 WATTS
2
VIDEO 1 VIDEO 3 VIDEO 4
IN OUT
VIDEO 2
IN OUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
MON
OUT
SOFTWARE
COMPUTER
UPGRADABLE
I/O
RIGHT LEFT
A
SPEAKERS
B
RIGHT LEFT
SAT/CABLE/HDTV
DVD
SPEAKER IMPEDANCE MINIMUM
A OR B 4 OHMS PER SPEAKER
A AND B 8 OHMS PER SPEAKER
RIGHT LEFT
AUDIO VIDEO
OUTPUTS
POWER
ON
OFF
8: VCR
AM
LOOP
ANTENNA
COMPOSITE
VIDEO
ZONE 2
OUT
L
R
LINE OUTPUTS
ZONE 3
OUT
GND
ZONE 4
OUT
RIGHT LEFT
AUDIO
ZONE 2
ZONE 3 ZONE 4
12V TRIG OUT
PHONO
L
R
EXT
REM
ALL
TAPE
IN OUT
IR
OUT
AM/FM STEREO RECEIVER
1
MODEL NO. : RX-1052
POWER CONSUMPTION: 300 WATTS
2
VIDEO 1 VIDEO 3 VIDEO 4
IN OUT
VIDEO 2
IN OUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
MON
OUT
SOFTWARE
COMPUTER
UPGRADABLE
I/O
RIGHT LEFT
A
SPEAKERS
B
RIGHT LEFT
RIGHT LEFT
AUDIO
SPEAKER IMPEDANCE MINIMUM
A AND B 8 OHMS PER SPEAKER
A OR B 4 OHMS PER SPEAKER
COMPOSITE
VIDEO
POWER
ON
OFF
IR IN
CD
REC INPUTS
Loading...