Quick Guide
Turnkey Kit – Initial Connection
Introduction
Thank you for buying the Rosslare turnkey kit. This quick guide will assist you though your initial
connection. For more detailed instructions, please refer to each component's manual, which can be
found on our website.
Kit Contents
Access control panel
2 readers, 25 credentials (AC-225IP)
4 readers, 50 credentials (AC-825IP)
Mini-PC
Mini-PC Accessories
HDMI to VGA adapter
HDMI to HDMI cable
Power supply for Mini-PC
Mounting Accessories for Access Control Panels
AC-225IP AC-825IP
Mounting screws 3 (M3.5 x 32) 5 (#10 x 1-1/4”)
Wall anchors 3 5
Metal enclosure keys 2 2
EOL resistor kit (2.2K and 8.2K) 4 each 4 each
Terminal block extraction tool 1
Power cable 1
Power lock kit 1
Mounting Accessories for Readers
AC-225IP AC-825IP
Mounting screws (M3 x 25) 4 8
Wall anchors 4 8
Pin Torx security screws 2 4
Pin Torx key tool 1 1
Mounting template labels 2 4
0706-09
60624+00
Connectivity
1. Connect the Mini-PC to the power using the included power supply.
2. Connect a HDMI monitor. If you don't have one, connect a HDMI to DVI adapter or consult a
Rosslare representative.
3. Connect a keyboard and a mouse to the Mini-PC using the two USB ports of the Mini-PC.
4. Connect the Mini-PC to your LAN using an Ethernet cable.
5. Connect the access controller to the same LAN as the Mini-PC using an Ethernet cable.
6. Turn the Mini-PC on by pressing the power button for 2 seconds. A blue LED should appear.
The Mini-PC shows the AxTraxNG Ultralight software pre-installed.
Information
Learn more about all our product range at
www.rosslaresecurity.com
Loading...