Ross RANCN65 Instructions Manual

Protect yourself and others by observing all safety information, warnings, and cautions. Failure to
comply with instructions could result in personal injury and/or damage to product or property.

Please retain instructions for future reference!

RANCN65

65MM COIL

NAILER

ADJUSTABLE
EXHAUST

AIR INLET

TRIGGER

MODE CONTROL
SINGLE / BUMP

DEPTH CONTROL

MAGAZINE RELEASE

NOTE: USE PLASTIC
COLLATED NAILS ONLY

Nail capacity (Qty): up to 300pcs
Nail size: 25 mm (1”) to 65mm (2-1/2”), 15deg, Plastic collated coil nails only.
Recommended operating pressure: 70-110 PSI (5-7.5 bar)
Maximum pressure: 8.3 bar (120 PSI)
Air inlet: Nitto style connector
Dimensions: 320 x 310 x 128 mm
Weight: 3.0 kg

• KEEP CHILDREN AWAY. All children should be kept away from the work area. Don’t let them
handle the tool.

• USE SAFETY GOGGLES AND EAR PROTECTION: Air tool operators and others in work area
should always wear safety glass to prevent the injury from fasteners and flying debris
when loading and unloading this tool. Maybe the noise would harm your hearing, wear the
ear protection to safeguard.

• NEVER USE OXYGEN, COMBUSTIBLE OR ANY OTHER BOTTLE GAS
as a power source or would cause explosion and serious personal injury.

• DO NOT CONNECT TOOL TO COMPRESSED AIR which pressure exceeds (8.3bar) 120psi.

• DO NOT PLACE OVER-LONG AIR HOSE in working area in case of the

• operator’s unexpected tripping .Make sure all connections are tight, the hose should be

near to air supply .

• CARRY THE TOOL ONLY BY THE HANDLE. Do not keep the trigger pull on safety yoke mecha­nism to avoid unintentional firing of fastener.

• KEEP THE TOOL POINTED AWAY FROM YOURSELF and others at all time and keep hands, any
body parts away rear area to Safety guard against possible injury.

• DISCONNECT TOOL FROM AIR SUPPLY BEFORE LOADING fasteners to prevent a fastener from
being fired during connection.

• DO NOT KEEP THE TRIGGER OR SAFETY DEPRESSED during loading fasteners or the uninten­tional firing of a fastener would cause personal injury.

• DISCONNECT TOOL FROM AIR SUPPLY HOSE and empty the compressor before performing
maintenance or when not in use.

• DO NOT DRIVE FASTENER ON SCAFFOLDINGS,LADDERS and on such similarly construction,
not working on airtight case, and vehicles. Don’t over reach, keep proper footing at all
times to ensure correct balance.

• DO NOT DRIVE FASTENERS CLOSE TO THE EDGE OF THE WORK PIECE.

• The work-piece would split allowing fastener to fly free or ricochet causing personal injury.

• DO NOT DRIVE FASTENER ON TOP OF NAILED FASTENER, or the fastener can ricochet causing

personal injury.

• NEVER USE A TOOL that is leaking air, had missing or damaged parts or requires repair and
make sure all the screws and securely tightened.

• MAKE DAILY INSPECTION FOR FREE MOVEMENT of trigger, safety mechanism and spring to
insure the tool can operate well.

• ONLY USE PARTS AND ACCESSORIES recommend by manufacturer.

GENERAL SAFETY

SPECIFICATIONS

IMPORTANT!: Read and understand all safety rules, operating
instructions before use.