Rosewill RX20-U2 User Manual
Rosewill RX20-U2 USB 2.0
User Manual
Rosewill 2.5” ATA to USB2.0 High Speed External Hard Drive Enclosure
Table of Contents
Chapter 1 Introduction................................................................................ P.02
Chapter 2 Package Contents...................................................................... P.03
Chapter 3 Hardware Installation Guide...................................................... P.04
Chapter 4 Installation Procedure................................................................ P.09
Chapter 5 Unplug Procedure...................................................................... P.12
Chapter 6 Partitioning & Formatting..............................................................P.15
Chapter 7 Performance Test..........................................................................P.18
- 1 -
Chapter 1
Introduction
1.1 The Rosewill RX20-U2 is a slim, compact and outstanding looking
IDE to USB 2.0 external Hard Drive enclosure. The case is made of
aluminum and as one of the smallest enclosures available nowadays,
a 2.5” HDD with a thickness of 9.5mm fits exactly. Being small enough
to fit in your pocket, makes it very convenient for carrying your data
while on the go, no matter if used on a PC or a Mac.
1.2 System Requirement
a. Hardware: PC or MAC with USB interface
b. OS requirement: Windows 98/SE, Windows ME
Windows 2000, Windows XP
Mac OS 8.6 and above
1.3 Product Dimension: 12.5cm x 7.6cm x 1.3cm
4.92” x 2.99” x 0.53”
- 2 -
Chapter 2
RX20-U2
Package Contents (may vary between your product and the items stated below)
1. RX20-U2 (ATA to USB 2.0 External Hard Drive Enclosure)
2. USB 2.0 Cable
3. CD with Driver
- 3 -
Chapter 3
Hardware Installation Guide
3.1 Exploded View
(See Figure A)
3
2
4
5
1
Figure A
- 4 -
3.2 Chassis Assembly
Unscrew the two screws, then remove the back panel
(See Figure B - D)
Figure B
Figure C
Figure D
- 5 -
3.3 Hard Drive Installation
Connect the hard drive, install it and fasten the screws
(See Figure C - G)
Figure C
Figure D
Hard Drive jumper settings: Set to “Master”!
Hard Disk maximum thickness: 9.5mm
- 6 -
Loading...