This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device
and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations.
The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user
may be required to take adequate measures.
National Restrictions
2400.0-2483.5 MHz
Country Restriction Reason/remark
Bulgaria
France Outdoor use limited to 10 mW
Italy
e.i.r.p. within the band 2454-2483.5
MHz
General authorization required for outdoor use and public service
Military Radiolocation use. Refarming of the 2.4 GHz band has
been ongoing in recent years to allow current relaxed regulation.
Full implementation planned 2012
If used outside of own premises, general authorization is
2
Wireless N Adapter RNX-N150UBE User Manual
required
Luxembourg
Norway Implemented
Russian
Federation
Note: Please don’t use the product outdoors in France.
Only for indoor applications
General authorization required for network and service
supply(not for spectrum)
This subsection does not apply for the geographical area within a
radius of 20 km from the centre of Ny-Ålesund
Thank you for choosing Rosewill’s 802.11n Wireless USB adapter – RNX-N150UBE.
This chapter is to introduce you more about this Wireless Adapter.
Package Content
Before getting started, please verify that your package includes the following items:
1. Rosewill 802.11n Wireless USB Adapter x 1
2. 2 dBi detachable Antenna x 1
3. Extended USB Base x 1
4. Quick Installation Guide x 1
5. Resource CD x 1, including:
Rosewill Wireless N Client Utility and Driver
User Manual
Note:
Make sure that the package contains the above items. If any of the listed items are damaged or missing,
please contact with your distributor.
1.1 Overview of the Product
The adapter is an 802.11n client device; it is designed to provide a high-speed and
unrivaled wireless performance for your computer or notebook. With a faster wireless
connection, you can get a better Internet experience, such as downloading, gaming, video
streaming and so on.
With the 802.11n technology, the RNX-N150UBE allows high packet transfer rate of up to
1500Mbps for maximum upload and download throughput. It can also interoperate with
other wireless (802.11b, 802.11g) standard. The adapter supports WEP, WPA and WPA2
encryption to prevent outside intrusion and protect your personal information from being
exposed.
The adapter is easy to install and manage. The Quick Setup Wizard guides you
step-by-step through the installation process; the Rosewill Wireless N Client Utility helps
you create a wireless connection immediately.
With unmatched wireless performance, reception, and security protection, the
RNX-N150UBE is the best choice for easily adding or upgrading wireless connectivity to
your notebook and computer.
5
Wireless N Adapter RNX-N150UBE User Manual
1.2 Features
Complies with IEEE802.11n, IEEE802.11g, IEEE802.11b standards
Supports WPA/WPA2 data security, IEEE802.1x authentication, TKIP/AES
encryption, and 64/128 - bit WEP encryption
Supports up to 150Mbps download speed for maxi mum throughput
Ease to configure and provides monitoring information
Supports Windows 2000, XP, Vista, 7
Supports WPS
1.3 Product Specification
Standard
RF Output Power(Typical)
IEEE 802.11n and IEEE802.11g/b
Frequency Band
2.400GHz ~ 2.484GHz
Data Rate
802.11n: up to 150Mbps Upstream and downstream
802.11g: 54, 48, 36, 24, 18, 12, 9 & 6Mbps
802.11b: 11, 5.5, 2 and 1 Mbps with auto-rate fall bac k
Sensitivity
-90dBm @ 802.11n
-92dBm @ 802.11g
-95dBm @ 802.11b
Dimension:
6.5 (L) x 5.5 (W) x 1.3 (H) (Inch)
180 (L) x 180 (W) x 50 (H) (mm)
Weight:
802.11b: up to 20 ± 1 dBm
802.11g: up to 16 ± 1 dBm
802.11n: up to 15 ± 1 dBm
Interface
USB 2.0 A-TYPE
Antenna
2dBi External Detachable antenna
Driver support
Windows® 2000, XP 32/64, Vista 32/64,
Win7 32/64
Security
64/128-bit WEP (Hex & ASCII),
WPA/WPA2, WPA(TKIP with IEEE 802.1x)
/WPA2 (AES with IEEE 802.1x)
1.5 (lbs)
Operation Temperature
0°C ~ 60°C ambient temperature
Storage Temperature
-20°C ~ 70°C ambient temperature
Storage Humidity
10% ~ 90% (Non-condensing)
1.4 System Requirement
You must have at least the following
A laptop computer/desktop PC with an available USB port
At least a 300MHz processor and 32MB of memory
6
Wireless N Adapter RNX-N150UBE User Manual
Windows OS for Win98SE, ME, 2000, XP, Vista, 7
A CD-ROM Drive
USB controller properly installed and working in the computer
A 802.11n 、802.11g or 802.11b Wireless Access Point/Router (for infrastructure
Mode) or another 802.11n、802.11g or 802.11b wireless adapter (for Ad-Hoc;
Peer-to-Peer networking mode).
7
Wireless N Adapter RNX-N150UBE User Manual
Chapter 2 Installation Guide
2.1 Software Installation
Insert the Driver and Utility CD-ROM into the CD-ROM driver.
The Wizard should run automatically , and Figure 2-1 should appear. If not,
click the Start button and choose Run. In the field that appears, enter
D:\autorun.exe (if ‘’D’’ is the letter of your CD-ROM drive).
Figure 2-1
Next we use the USB wireless adapter installation steps as example. According to the PCI
wireless adapter installation steps, you can complete PCI wireless adapter installing
easily.
Click Install Driver & Utility for USB Wireless Adapter on the Wireless
Client Configuration Utility dialogue box, and then select the installing
language from the next screen and click Next button.
8
Loading...
+ 18 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.