Rosewill RNX-N150PCe User Manual
2.4GHz Wireless Lite-N PCI-E Adapter
RNX-N150PCe
User Manual
1910020431
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not in-stalled
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located or
operating in conjunction with any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is applicable to
only Mobile Configurations. The antennas used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.”
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.
2
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
National Restrictions
2400.0-2483.5 MHz
Country Restriction Reason/remark
Bulgaria
France Outdoor use limited to 10
Italy
Luxembourg
Norway Implemented
mWEIRP. within the band
2454-2483.5 MHz
General authorization required for outdoor
use and public service
Military Radiolocation use. Refarming of
the 2.4 GHz band has been ongoing in
recent years to allow current relaxed
regulation. Full implementation planned
2012
If used outside of own premises, general
authorization is
required
General authorization required for network
and service
supply(not for spectrum)
This subsection does not apply for the
geographical area within a radius of 20 km
from the centre of Ny-Ålesund
Russian
Federation
Note: Please don’t use the product outdoors in France.
Only for indoor applications
3
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Table of Content
Package Contents..........................................................................................5
Chapter 1 Overview ...................................................................................6
1.1 Overview of the product .................................................................................. 6
1.2 Features .......................................................................................................... 6
1.3 LED Status ...................................................................................................... 7
Chapter 2 Installation Guide.....................................................................8
2.1 Hardware Installation....................................................................................... 8
2.2 Software Installation........................................................................................ 8
2.2.1 Overview...................................................................................................... 8
2.2.2 Software Installation for Windows XP .......................................................... 8
2.2.3 Software Installation for Windows Vista ..................................................... 13
2.2.4 Software Installation for Windows 7........................................................... 16
Chapter 3 Configuration .........................................................................20
3.1 Current Status ............................................................................................... 20
3.2 Profile Management ...................................................................................... 21
3.2.1 Add or Modify a Configuration Profile ........................................................ 22
3.2.2 Remove a profile........................................................................................ 26
3.2.3 Switch another Profile................................................................................ 27
3.2.4 Export a Profile .......................................................................................... 27
3.2.5 Import a Profile .......................................................................................... 27
3.2.6 Scan Available Networks ........................................................................... 28
3.2.7 Auto Profile Selection Management........................................................... 28
3.3 Diagnostics.................................................................................................... 30
3.3.1 Check Driver Information ........................................................................... 30
3.3.2 Check Receive and Transmit Statistical Information.................................. 31
3.4 Configuration for Windows Vista ................................................................... 31
3.5 Configuration for Windows 7 ......................................................................... 33
Chapter 4 WPS Configuration ................................................................36
4.1 PBC (Push Button Configuration) method..................................................... 36
4.2 PIN method ................................................................................................... 39
4.2.1 Enter a PIN into your AP device ................................................................ 39
4.2.2 Enter the PIN from your AP device ............................................................ 40
Appendix A: Specifications.........................................................................42
Appendix C: FAQ .........................................................................................46
4
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Package Contents
The following items should be found in your package:
¾ One RNX-N150PCe 2.4GHz Wireless Lite-N PCI-E Adapter
¾ Quick Installation Guide
¾ One Resource CD for RNX-N150PCe, including:
• Wireless Lite-N Client Utility and Drivers
• User Guide
• Other Helpful Information
Note:
)
Make sure that the package contains the above items. If any of the listed items are
damaged or missing, please contact with your distributor.
Conventions:
The ‘Adapter’ mentioned in this user guide stands for RNX-N150PCe 2.4GHz Wireless
Lite-N PCI-E Adapter without any explanations.
5
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Chapter 1 Overview
Thank you for choosing RNX-N150PCe 2.4GHz Wireless Lite-N PCI-E Adapter.
1.1 Overview of the product
The adapter is an 802.11n client device; it is designed to provide a high-speed and
unrivaled wireless performance for your notebook. With a faster wireless connection, you
can get a better Internet experience, such as downloading, gaming, video streaming and
so on.
With the 802.11n technology, the RNX-N150PCe’s auto-sensing capability allows high
packet transfer rate of up to 150Mbps for maximum throughput. It has good capability on
anti-jamming, and it can also interoperate with other wireless (802.11b) products. The
adapter supports WEP, WPA and WPA2 encryption to prevent outside intrusion and
protect your personal information from being exposed.
The adapter is easy to install and manage. The Quick Setup Wizard guides you
step-by-step through the installation process; the Wireless Lite-N Client Utility helps you
create a wireless connection immediately.
With unmatched wireless performance, reception, and security protection, the
RNX-N150PCe is the best choice for easily adding or upgrading wireless connectivity to
your notebook computer.
1.2 Features
¾ Complies with IEEE802.11n, IEEE802.11g, IEEE802.11b standards
¾ Supports WPA/WPA2 data security, IEEE802.1x authentication, TKIP/AES encryption,
64/128/152-bit WEP encryption
¾ Supports high rate of up to 150Mbps for maximum throughput, supports automatically
adjust to lower speeds due to distance or other operating limitations
¾ Provides PCI-E interface
¾ Supports Ad-Hoc and Infrastructure modes
¾ Good capability on anti-jamming
¾ Supports roaming between access points when configured in Infrastructure mode
¾ Ease to configure and provides monitoring information
¾ Supports Windows 2000/ XP/ Vista/ 7
¾ The external antenna which are listed in a format of 1x1 for one receiver and one
transmitter.
6
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
1.3 LED Status
LED Indications Status Working Status
Status Solid Light
Flashing
Slowly
Activity
Flashing
Quickly
The adapter is inserted in the slot and the power
is on.
The adapter is trying to scan a networking
connection;
The adapter is already connected but is not
transmitting or receiving data.
The adapter is transmitting or receiving data.
7
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Chapter 2 Installation Guide
2.1 Hardware Installation
To install the adapter, follow these steps listed below:
1. Turn off your desktop PC and disconnect the power.
2. Remove your PC case and locate an available PCI-E slot on the motherboard.
Remove the metal slot cover on the back of the PC. Check with your computer
manufacturer for instructions if needed.
3. Slide the PCI-E Adapter into the PCI-E slot. Make sure that all of its pins are touching
the slot's contacts. Once the adapter is firmly in place, secure its fastening tab to your
PC's chassis with a mounting screw. Then, close your PC case.
4. Reconnect your PC’s power and turn on your desktop PC.
2.2 Software Installation
2.2.1 Overview
The Adapter’s Setup Wizard will guide you through the Installation procedure for Windows
2000/ XP/ Vista/ 7. The Setup Wizard will install the Wireless Lite-N Client Utility and
drivers.
When you install the hardware before installing the software, the system will prompt
“Found New Hardware Wizard”, click Cancel, and run the Setup Wizard program on the
CD-ROM.
The Setup steps for Windows 2000/ XP/ Vista/ 7 are very similar. The following setup
steps are for Windows XP/Vista/7.
2.2.2 Software Installation for Windows XP
1. Insert the Resource CD into your CD-ROM drive, and open the folder named
RNX-N150PCe. Double-click Setup.exe in the proper folder to start the installation,
then the following screen for preparing setup will appear.
8
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Figure 2-1
2. Figure 2-2 will display after a moment. Click Next to continue.
Figure 2-2
3. After that, you should choose a Setup type. It is recommended that you select Install
Client Utilities and Driver. Select Install Driver Only to install driver only (shown in
Figure 2-3). Click Next to continue.
9
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Figure 2-3
4. Click Browse to change the destination location for the software, then click Next in
the screen below (shown in Figure 2-4).
Figure 2-4
5. After that, select the program folder, you should create a new folder name or select
one from the Existing Folders list. It is recommended that you keep the default
setting. Click Next to continue the installation.
10
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Figure 2-5
6. Choose configuration tool, if you are not sure, please leave it default. Then click Next
to continue.
Figure 2-6
7. Wait a while for the setup as shown in Figure 2-7
11
.
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Figure 2-7
Note:
)
For Windows XP, the Setup Wizard will notify you of how to proceed with the
installation during these steps (shown in Figure 2-8). Our drivers have been tested
thoroughly, and are able to work with the operating system. Click Continue Anyway
to continue the Installation.
Figure 2-8
8. After all the steps above, you will see the screen below, click Finish to complete the
installation.
12
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Figure 2-9
2.2.3 Software Installation for Windows Vista
1. Insert the Resource CD into your CD-ROM drive, and open the folder named
RNX-N150PCe. Double-click Setup.exe in the proper folder to start the installation,
then the following screen for preparing setup will appear.
Figure 2-10
2. Soon, Figure 2-11 will display after a moment. Click Next to continue.
13
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Figure 2-11
3. Click Yes to continue.
Figure 2-12
4. The following page will display and please wait a moment.
14
2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual
Figure 2-13
)
Note:
For Windows Vista, the Setup Wizard will notify you of how to proceed with the installation
during these steps (shown in Figure 2-14). Our drivers have been tested thoroughly, and
are able to work with the operating system. Click Install this driver software anyway to
continue the Installation.
Figure 2-14
5. Click Finish to complete the installation.
15
Loading...