Rosewill RNX-G400 User Manual

54M Wireless AP Router RNX-G400

54M Wireless AP Router RNX-G400 User Manual

Prior to connecting the hardware, make sure to power off your Ethernet device, Cable/ADSL modem and Broadband

Router. Then follow the steps below to connect the related devices.

z Connect your computer to the LAN port.

Attach one end of the Ethernet cable with RJ-45 connector to your hub, switch or a computer’s Ethernet port, and the

other end to one of the LAN ports of your Broadband Router.

z Connect then Cable/ADSL Modem to the WAN port.

Connect the Ethernet cable attaching to your Cable/ADSL modem to the WAN port of your Broadband Router.

z Connect the power adapter.

Connect the single DC output connector of the power adapter to the power jack on the side of the Broadband Router.

Then plug the Power Adapter into an AC outlet.

z Power on the following devices in this order:

Cable/ADSL modem, Router, and PCs

The figure below illustrates a connection example:

Figure 1-1

You can manage the Broadband Router through the Web browser-based configuration utility. To configure the device via

Web browser, at least one properly configured computer must be connected to the device via Ethernet. The Broadband

Router is configured with the default IP address of 192.168.1.1 and subnet mask of 255.255.255.0 and its DHCP server is

enabled by default. Before setting up the Router, make sure your PCs are configured to obtain an IP (or TCP/IP) address

automatically from the Router by the steps below.

54M Wireless AP Router RNX-G400 User Manual

Please follow the steps below to setup your computer:

1. Go to Start Æ Settings Æ Control Panel

Figure 2-1

2. Double click the icon Network and Dial-up Connections

3. Highlight the icon Local Area Connection, right click your mouse, Click Properties

Figure 2-2

54M Wireless AP Router RNX-G400 User Manual

4. Highlight Internet Protocol (TCP/IP), then press Properties button

Figure 2-3

5. Choose Obtain an IP address automatically and Obtain DNS server address automatically, then press OK to

close the Internet Protocol (TCP/IP) Properties window

Figure 2-4

+ 9 hidden pages