Rosewill RGS-1016 User Manual
16 Ports Gigabit Switch RGS-1016
User Manual
COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice. is a
registered trademark of Rosewill Inc. Other brands and product names are trademarks
or registered trademarks of their respective holders.
No part of the specifications may be reproduced in any form or by any means or used to
make any derivative such as translation, transformation, or adaptation without
permission from Rosewill Inc. Copyright © 2010 Rosewill Inc. All rights reserved.
http://www.rosewill.com
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to
which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
2
Your product is marked with this symbol, which is
known as the WEEE mark. WEEE stands for Waste
Electronics and Electrical Equipment. It means that used
electrical and electronic products should not be mixed
with general waste. Used electrical and electronic
equipment should be treated separately.
CE Mark Warning
This is a class A product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.
Safety Warning
Place connecting cables carefully so that no one will step on them or
stumble over them.
Always disconnect all cables from this device before servicing or
disassembling.
Use ONLY an appropriate power adaptor or cord for your device.
Connect the power adaptor or cord to the right supply voltage (for example,
110V AC in North America or 230V AC in Europe).
Do not allow anything to rest on the power adaptor or cord and do not place
the product where anyone can walk on the power adaptor or cord.
Do not use the device if the power adaptor or cord is damaged as it might
cause electrocution.
If the power adaptor or cord is damaged, remove it from the power outlet.
Do not attempt to repair the power adaptor or cord. Contact your local
vendor to order a new one.
Do not use the device outside, and make sure all the connections are
indoors.
Do not obstruct the device ventilation slots, as insufficient airflow may harm
your device.
Do not use this product near water, eg, in wet basement, or near a
swimming pool.
Do not expose your device to dampness, dust or corrosive liquids.
Do not install, use, or service this device during a thunderstorm. There is a
remote risk of electric shock from lightning.
Connect ONLY suitable accessories to the device.
Do not open the device or unit. Opening or removing covers can expose
you to dangerous high voltage points or other risks. ONLY qualified service
personnel should service or disassemble this device. Please contact your
vendor for further information.
Make sure to connect the cables to the correct ports.
If you wall mount your device, make sure that no electrical lines, gas or
water pipes will be damaged.
3
Loading...