Rosewill RCW-605 User Manual

USB TO IDE 2.5”+3.5”+SATA Cable RCW605

User Manual

USB TO IDE 2.5”+3.5”+SATA Cable RCW605

USB TO IDE 2.5”+3.5”+SATA Cable

Compliance

• Compliance with Gen1i, and Gen1m of Serial ATA II Electrical Specification 1.0

• Compliance with USB 2.0 (Hi-Speed) electrical specification

• Compliance with USB Mass Storage Class Bulk-Only Transport Specification

Specifications

• Compliance with Gen1i of Serial ATA II Electrical Specification 1.0

• Support SATA Spread-Spectrum Clock

User Manual

• Support SATA II Asynchronous Signal Recovery (Hot Plug) feature

• Compliance with USB 2.0 electrical specification

• Support USB High-Speed and Full-Speed Operation

• Compliance with USB Mass Storage Class, Bulk-Only Transport Specification

• Support ATA/ATAPI PACKET command set

• Support ATA/ATAPI LBA48 addressing mode

• Support 12MHz external crystal

• Support external NVRAM for Vender Specific VID/PID, Manufacture, Product String of

USB Device Controller

• Support SCSI-2 Vender Specific Command for GPIO access

• Support SCSI-2 Vender Specific Command for NVRAM access

• Support SCSI-2 Vender Specific Command for ATA PIO command access

• Support ATA/ATAPI device power down control in USB Suspend mode Embedded 3.3V

to 1.8V voltage regulator

• Single power 3.3V power supply

• 0.18um CMOS technology

• 64 LQFP package

System Requirements

Microsoft Windows 98

Microsoft Windows ME, 2000, XP, 2003, Media Center, and later

Mac OS 9.22 and above

1

USB TO IDE 2.5”+3.5”+SATA Cable RCW605

User Manual

Package Contents

RCW-605 X 1

User manual X 1

Power adapter X 1

SATA cable X 1

SATA to 4 pin power cable X 1

Drive disc X 1

Installation

1. Plug the 2.5” or 3.5” ATA/ ATAPI / SATA device to RCW-605 by IDE or SATA interface.

(Please notice the direction of IDE or SATA port) Please check a to d as below.

(only available in RCW605)

SATA

3.5"

5.25"

a. 3.5" ATA hard drive

2.5"

b. 2.5" ATA hard drive

2.5" HD

2