5-port Gigabit Desktop Switch RC-409LX
User Manual
5-port Gigabit Desktop Switch RC-409LX User Manual
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to
take adequate measures.
- 2 -
5-port Gigabit Desktop Switch RC-409LX User Manual
Before We Begin
Thank you for purchasing this product, we would like to use this manual to help you know more about your
products.
COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice.
is a registered trademark of ROSEWILL INC. Other brands and product names are trademarks
or registered trademarks of their respective holders. No part of the specifications may be reproduced in any
form or by any means or used to make any derivative such as translation, transformation, or adaptation without
permission from ROSEWILL INC.
Copyright © 2009 ROSEWILL INC.
All rights reserved.
http://www.rosewill.com
Special Icons that needs your attention:
NOTE: This mark indicates that there is a note of interest or something you need to
pay special attention to.
WARNING: This mark indicates warning or caution that there might be something
can damage your device or property.
- 3 -
5-port Gigabit Desktop Switch RC-409LX User Manual
Package Contents
The following items should be found in your package:
One RC-409LX 5-port Gigabit Desktop Switch
One Power Adapter for RC-409LX 5-port Gigabit Desktop Switch
This User Guide
Note:
Make sure that the package contains the above items. If any of the listed items are damaged or
missing, please contact with your distributor.
Safety Notices
Cautions:
Do not use this product near water, for example, in a wet basement or near a swimming pool.
Avoid using this product during an electrical storm. There may be a remote risk of electric shock from
lightning.
Convention
The Switch or RC-409LX mentioned in this User Guide stands for RC-409LX 5-port Gigabit Desktop
Switch without any explanation.
- 4 -
5-port Gigabit Desktop Switch RC-409LX User Manual
Chapter 1 Introduction of the Product
Thank you for choosing the RC-409LX 5-port Gigabit Desktop Switch.
Overview of the Product
Powered by the Gigabit Ethernet Technology, the RC-409LX 5-port Gigabit Desktop Switch provides
the seamless network connection, which can speed up your old network to 1000Mbps. The increased
speed and backbone connections make Gigabit a reality, which ensures the graphics, CGI, CAD, or
multimedia files and other applications with bandwidth-intensive files transferred across the network
almost instantly.
The non-blocking switching architecture adopted in the RC-409LX greatly improves network
response times as well as significantly speed up the traffic between subnets by forwarding and
filtering packets at full wire-speed for maximum throughput.
The RC-409LX switch is compatible with all 10Mbps, 100Mbps, and 1000Mbps Ethernet devices,
which can protect your existing network investments while provide you a straightforward migration
path to faster Gigabit speed.
The RC-409LX switch is very easy to manage since it is plug-and-play and no configuration is
needed. In addition, the auto MDI/MDI-X cable detection on all ports eliminates the demand of
crossover cable or Uplink port. Each port can be used as general ports or Uplink ports, and any port
can be simply plugged into a server, a hub, a router or a switch, using the straight cable or crossover
cable. Diagnostic LEDs which display link status and activity, allowing you to quickly detect and
correct problems on the network.
The RC-409LX switch adopts Green Ethernet technology, supports power saving features to help
make your network environmentally friendly without compromising performance. The switch
automatically powers down ports that have no link, budgets power output for different Ethernet cable
lengths.
Features
Supports Green Ethernet technology to implement power saving features
Complies with IEEE802.3, IEEE802.3u, IEEE802.3ab standards
5 10/100/1000M RJ45 ports
Supports IEEE802.3x flow control for Full-duplex Mode and backpressure for Half-duplex
Mode
Non-blocking switching architecture that forwards and filters packets at full wire-speed for
maximum throughput
4K entry MAC address table of the RC-409LX with auto-learning and auto-aging
- 5 -
5-port Gigabit Desktop Switch RC-409LX User Manual
Supports for Jumbo frames of up to 9KB
LED indicators for monitoring power, link, speed and activity
External power adapter supply
- 6 -
5-port Gigabit Desktop Switch RC-409LX User Manual
Chapter 2 Installation
Mounting the Switch on a Desk
To install the Switch, please follow the steps:
1 You can place the Switch on a flat desk.
2 Please inspect the Power Adapter carefully and make sure that it is properly connected to a power
source.
3 Ensure adequate ventilation space around the switch for dissipating heat and air.
Note:
Please avoid any heavy thing placed on the switch.
Power On
RC-409LX 5-port Gigabit Desktop Switch can be used with DC power supply. Powering on the
Switch, it will automatically initialize and its LED indicators will respond as follows:
Name Time Status Indication
Power All the time On Power on
LEDs
(port
1-5)
Note:
1st-3rd
second
4th-6th
second
7th
second ~
Off N/A
On (yellow) No device connected to the corresponding port.
There is a 10/100/1000Mbps device connected to the
On (green)
corresponding port.
Off No device connected to the corresponding port.
There is a 10/100Mbps device connected to the corresponding
On (yellow)
port.
There is a 1000Mbps device connected to the corresponding
On (green)
port
If the LED indicators don’t respond as described above, please check the power supply and its
connection.
- 7 -
5-port Gigabit Desktop Switch RC-409LX User Manual
Chapter 3 Identifying External Components
This Chapter describes the front panel, rear panel and LED indicators of the Switch.
Front Panel
Figure 3-1 RC-409LX Switch Front Panel
The Switch’s LEDs are located on the front panel (View from left to right).
Name Status Indication
Power
On
(green)
Off Power off
Power on
On
There is a 1000Mbps device connected to the corresponding port.
(green)
1000Mbps
Flashing
Data transmitting or receiving on corresponding port.
(green)
Off No 1000Mbps device connected to the corresponding port.
On
There is a 10/100Mbps device connected to the corresponding port.
(yellow)
10/100Mbps
Flashing
Data transmitting or receiving on corresponding port.
(yellow)
Off No 10/100Mbps device connected to the corresponding port.
Note:
The LEDs’ description above explains the device’s working status after initialization.
Rear Panel
Figure 3-2 RC-409LX Switch Rear Panel
The following parts are located on the rear panel (View from left to right).
POWER: The POWER socket is where you will connect the power adapter. Please use the power
adapter provided with this RC-409LX Switch.
Port (1-5): The RC-409LX Switch is equipped with 5 10/100/1000M RJ45 ports where you will
connect your network devices. The working status can be indicated by the corresponding LEDs on
the front panel.
- 8 -
5-port Gigabit Desktop Switch RC-409LX User Manual
Appendix A: Specifications
General
Standards IEEE802.3, IEEE802.3u, IEEE802.3ab
Topology Star
Protocol CSMA/CD
Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex)
Data Transfer Rate
Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full Duplex)
Gigabit Ethernet: 2000Mbps (Full Duplex)
10Base-T: UTP category 3, 4, 5 cable (maximum 100m)
EIA/TIA-568 100Ω STP (maximum 100m)
Network
Media(Cable)
100Base-TX: UTP category 5, 5e cable (maximum 100m)
EIA/TIA-568 100Ω STP (maximum 100m)
1000Base-TX: UTP category 5 cable (maximum 100m)
EIA/TIA-568 100Ω STP (maximum 100m)
Number of Ports 5 10/100/1000M RJ45 ports
LED indicators Power, 10/100/1000Mbps Link/Act
Transfer Method Store-and-Forward
MAC Address
Automatically learning, automatically aging
Learning
10Base-T: 14880pps/Port
Frame Filter Rate
100Base-Tx: 148800pps/Port
1000Base-T: 1488000pps/Port
10Base-T: 14880pps/Port
Frame Forward Rate
100Base-Tx: 148800pps/Port
1000Base-T: 1488000pps/Port
Environmental and Physical
Operating T em perature
Storage Temperature
0℃~40℃ (32℉~104℉ )
-40℃~70℃ (-40℉~158℉)
Operating Humidity 10%~90% non-condensing
Storage Humidity 5%~90% non-condensing
- 9 -
5-port Gigabit Desktop Switch RC-409LX User Manual
Appendix B: Troubleshooting
1. The Power LED is not lit
Check to see if the DC power cord is connected to the Switch properly, and make sure the power
source is ON.
2. The Link/Act LED is not lit when a device is connected to the corresponding port
Check to see if the cable connectors are firmly plugged into the Switch and the device, and verify the
connected device is turned on and working well. Make sure the cable is not longer than 100 meters
(328feet).
Thank you for purchasing a quality Rosewill Product.
Please register your product at: www.rosewill.com for complete warranty information and future
support for your product.
Support: techsupport@rosewill.com
- 10 -
Loading...