Rosewill QBLF1007 User Manual

Thank you for purchasing a Rosewill Automatic Pet Water Fountain.

Please read the instruction manual before use and retain for future reference.

PRODUCT OVERVIEW

Water Outlet

Water Basin Water Pump

Filter

RPWF-21001

Night Light

Filter Cover

Base

Power Cable

Power Adapter

USB Cable

HOW TO USE

1. Remove the lter and rinse it with fresh water before use.
NOTE: It is recommended that this lter be replaced once every 1 to 2 months.

2. Remove the water basin from the water fountain and install the lter onto it as seen in the
diagram below.

NOTE: Make sure that the lter cover snaps into place on both sides.

3. Run the power cable attached to the water pump through the cable hole located inside the
water fountain.

1

4. Add water to the water fountain until the water
level is between the MIN and MAX lines located
on the inside of the water fountain. Replace the
water basin once the water is added.

5. Plug the USB-A end of the included USB cable into the included power adapter.

6. Plug the power adapter into a powered outlet.

7. Plug the other end of the cable into the power cable that runs from the water pump.

8. The water fountain should start immediately.

CLEANING

Cleaning the Fountain

1. Before cleaning the base and other parts, remove
water basin from the water fountain and remove all of
the water inside.

2. Remove the water pump.

3. Clean the water fountain with a dry cloth.

NOTE: It is recommended that the water fountain be
cleaned once a week.

Cleaning the Water Pump

1. Remove the protective cover, spong lter, adjuster piece, impeller shroud, and impeller, in
that order.

2. Clean any debris and hair within the chamber

NOTE: It is recommended that the water pump be cleaned once a week.

Pump Impeller Impeller Shroud Adjuster Piece Sponge Filter Cover

2