Rosen CLEARVUE User Manual

Table of Contents

Quick Reference Guide 3

Using the System

Getting Started 4
Lowering the Screen 4
Functional Remote Buttons 5
Using the VCR 6
Using the TV Tuner 7
Using the Auxiliary Inputs 8
Changing the Video Settings 8
Listening over the Vehicle Speakers 9
Listening to Auxiliary Audio Sources 9
Listening with the Headphones 10

Battery Replacement

Replacing the Headphone Batteries 11
Replacing the Remote Batteries 11

Frequently Asked Questions 12

Page 2

Quick Reference Guide

To lower the screen:

Release button

Press the release button as shown.

To watch a videotape:

Turn the ignition switch to the Run
or Acc position.
Press the

POWER button on the remote.

Insert a videotape into the VCR. It will begin playing automati­cally , and the tape’ s picture will appear on the screen.

To listen over the vehicle speakers:

Turn on the vehicle radio and tune it to 89.1 FM.
Press the
Press and release the

until

POWER button on the remote.

SPEAKER ON/OFF button on the remote

“FM ON” is displayed on the screen.

If no sound is heard, try 88.7 FM.

To use an AUX source:

(such as an optional videogame or camcorder)

Connect the RCA audio and video outputs of the device to the
Line 2 Inputs on the front of the VCR.

Press and release the “MODE” button until “LINE 2” is dis­played on the screen. The aux source image should now be
visible on the screen.

To watch broadcast television:

(requires the optional TV Antenna)

Turn the ignition switch to the Run or Acc position.
Press the
Press and release the

current channel number are displayed (for example, “CH 2”).
Use the

POWER button on the remote.

MODE button until ”CH___” and the

PREV TRK and NEXT TRK buttons to change channels.

Page 3

Using the System

Getting Started

The ClearVue system consists of the following components:

n A Video Cassette Recorder/Player
n An overhead Monitor
n Wireless Headphones (2 pair)
n A Remote Control
n A TV Tuner (requires the optional TV Antenna for use)
n An FM Modulator (allows the system’s sound to be

heard over your vehicle’s speakers).

n Other parts and cables which are installed out of

sight in your vehicle.

The ClearVue system is intended to be used with your ignition
key switch in the Run or Acc position. Extended viewing of the
system without the engine running should be avoided, as it
could drain the battery .

Lowering the Screen

Press the Release button located here.

Adjustment
Knob

The screen will lower itself into the viewing position. To change
the viewing position, insert two fingers into the adjustment
knob’s finger indentations, and rotate as needed.

Page 4