Rosemount Removing Junction Box from a sensor and Installing an 8732E Transmitter Manuals & Guides

Reference Manual
00809-0200-4725, Rev AA November 2011
Rosemount 8732E
Removing the Junction Box from a Sensor (Rosemount 8705 or
8711) and Installing the Rosemount 8732E Integral Transmitter
Tools Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 1
Step 2: Remove junction box . . . . . . . . . . . . . . . . . . . . . .page 2
Step 3: Insert wire harness pins . . . . . . . . . . . . . . . . . . . .page 2
Step 4: Tighten the terminal block screws . . . . . . . . . . . . page 3
Step 5: Position the transmitter . . . . . . . . . . . . . . . . . . . . page 3
Step 6: Reinstall bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 4
The following Manual Supplement contains step by step instructions for removing the junction box from a sensor (Rosemount 8705 or 8711) and installing a Rosemount 8732E integral transmitter.

Tools Required

3
/16-in. bent allen wrench
Small slot tip screwdriver

Step 1: Remove bolts Using the allen head wrench, remove the four bolts holding the junction box

onto the sensor. Set the bolts aside for later use.
www.rosemount.com
Rosemount 8732E
Reference Manual
00809-0200-4725, Rev AA
November 2011

Step 2: Remove junction box

Remove the junction box exposing the terminal block of the sensor. Note that there is an o-ring in a retaining groove on the pedestal of the sensor. Make sure that the o-ring stays in place.

NOTE

Make sure the terminal block openings are all the way open.

Step 3: Insert wire harness pins

2
Position the transmitter to allow for the insertion of the wire harness pins to be installed into the terminal block of the sensor.
Reference Manual
00809-0200-4725, Rev AA November 2011
Rosemount 8732E

Step 4: Tighten the terminal block screws

Step 5: Position the transmitter

While supporting the 8732 transmitter, use a small slot tip screwdriver to tighten the screws of the terminal block securely.
With the wire harness attached, position the transmitter over the sensor and set upon the sensor. Make sure that the o-ring is properly seated in the retaining grove to prevent it from being pinched.
3
Reference Manual
00809-0200-4725, Rev AA
Rosemount 8732E
November 2011

Step 6: Reinstall bolts With the transmitter in position, use the allen head wrench to reinstall the four

bolts set aside in Step 1.
After all four bolts are installed and tightened, the installation is complete. Please refer to the Quick Installation Guide (0082 5-0100- 4727) for instruction
on grounding, powering, and configuring the transmitter.
4
Loading...