Rose displays ECONOSTAND WITH ANOGOTCHA User Manual

EconoStand™
Parts
Instruction Sheet
AnoGotcha Shell
12AG400
T-Top Gotcha
Instructions for Assembly
Step 1
Assemble bottom holder bracket onto lower pole section (this is the thicker section of pole).
Step 2
Screw pole onto baseplate. Tighten securely.
Step 3
EconoStand
components
Pole
Bottom
Holder Bracket
1 2
3 4
Base Plate
To p
Thumb
Screw
To p
Holder Bracket
Step 4
Insert T-Top Gotcha Holder into the AnoGotcha Shell.
Step 5
Slide AnoGotcha onto brackets.
5 6
Step 6
Install end caps after assembly to brackets.
The Gotcha® is a registered trademark and EconoStandTM and AnoGotcha™ are tradmarks of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSEcono/AnoGotcha
Incept- 9.10.02
Continued on next page
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
EconoStand™
Parts
Instruction Sheet
AnoGotcha Shell
12AG400
T-Top Gotcha
Instructions for Assembly
Step 7
Snap the AnoGotcha Holder com­pletely open so that hinge is turned up as far as possible. Insert poster into holder until top of poster meets top of holder. To close snap the AnoGotcha Holder shut. Note: With large or curling graphics, it may be easier to insert graphic at one end and slide into holder from one end to another.
Step 8
To close snap the AnoGotcha Holder shut.
EconoStand
components
Pole
Bottom
Holder Bracket
7 8
9
Base Plate
To p
Thumb
Screw
To p
Holder Bracket
Step 9
Adjust height of stand as necessary.
The Gotcha® is a registered trademark and EconoStandTM and AnoGotcha™ are tradmarks of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSEcono/AnoGotcha
Incept- 9.10.02
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Loading...
+ 2 hidden pages