Rose displays CLEAR LOCKING HOOKS User Manual

Clear Locking Hook

PARTS

™

Instruction Sheet

Clear Locking Hook

25-0100 Single

Instructions For Hanging

Step 1

Place open end of hook through pre-punched hole
in poster or graphic, or though clip on holder.

Step 2

Look closely at the opening in hook. It resembles a
racetrack. Place post on end of hook into top end
of the racetrack. DO NOT FORCE the post into
the hole.

Step 3

Once post has been inserted into top end of the
race track, flex hook slightly to allow post to slide
into lower end of the racetrack. This will lock the
post in place.
Note: To unlock the hook- reverse the process.

Instructions for Clear Locking
Hook & Clear Anchor Assembly:

25-0100 single hook used with clear base.

Step 1

If using this assembly you should also have clear
anchor bases. (Parts shown to right) Place open
end of hook through anchor- from the top of the
anchor base.

Step 2

See individual holder instructions for hanging.

Clear Locking Hook

25-0200 Double

Step 1 Step 2 Step 3

Flex

Step 1 side view Step 3 side view

RAN-Base-D

RAN-Base-S

The Clear Locking Hook is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #99INSCLH

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

Clear Locking Hook

PARTS

™

Instruction Sheet

Clear Locking Hook

25-0100 Single

Instructions For Hanging

Step 1

Place open end of hook through pre-punched hole
in poster or graphic, or though clip on holder.

Step 2

Look closely at the opening in hook. It resembles a
racetrack. Place post on end of hook into top end
of the racetrack. DO NOT FORCE the post into
the hole.

Step 3

Once post has been inserted into top end of the
race track, flex hook slightly to allow post to slide
into lower end of the racetrack. This will lock the
post in place.
Note: To unlock the hook- reverse the process.

Instructions for Clear Locking
Hook & Clear Anchor Assembly:

25-0100 single hook used with clear base.

Step 1

If using this assembly you should also have clear
anchor bases. (Parts shown to right) Place open
end of hook through anchor- from the top of the
anchor base.

Step 2

See individual holder instructions for hanging.

Clear Locking Hook

25-0200 Double

Step 1 Step 2 Step 3

Flex

Step 1 side view Step 3 side view

RAN-Base-D

RAN-Base-S

The Clear Locking Hook is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #99INSCLH