Rose Displays Cable Cord Spider User Manual

Cable/Cord SpiderTM Anchor with Loop and Saucer

Parts

Instruction Sheet

1 Spider Anchor

RAN-BASE-CC

Instructions For Hanging

Step 1

Push Saucer up through large hole in bottom of
spider anchor. Fig. 1
Slide Saucer into pocket next to the hole. Pull
cable tight.

Step 2

Slide loop end of cable around center of
MultiClip. Holding clip at slight angle, first insert
one round end, then press down on other end and
push MultiClip into holder. Repeat for second
MultiClip. Fig. 2

Note: For directions on how to use a specific
holder to hang your poster, refer to the appropri­ate instruction sheet.

1 Loop and

Saucer

16-0018SL

1

MultiClip

1UP-0100

Figure 1

The Spider Anchor is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSCCSpiderAnchorLoopSaucer

Incept-9.12.02

Figure 2

35 Congress Street, Salem MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

Cable/Cord SpiderTM Anchor with Loop and Saucer

Parts

Instruction Sheet

1 Spider Anchor

RAN-BASE-CC

Instructions For Hanging

Step 1

Push Saucer up through large hole in bottom of
spider anchor. Fig. 1
Slide Saucer into pocket next to the hole. Pull
cable tight.

Step 2

Slide loop end of cable around center of
MultiClip. Holding clip at slight angle, first insert
one round end, then press down on other end and
push MultiClip into holder. Repeat for second
MultiClip. Fig. 2

Note: For directions on how to use a specific
holder to hang your poster, refer to the appropri­ate instruction sheet.

1 Loop and

Saucer

16-0018SL

1

MultiClip

1UP-0100

Figure 1

The Spider Anchor is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSCCSpiderAnchorLoopSaucer

Incept-9.12.02

Figure 2