Rose displays ANOSKYBOX-TOP LOADING 4 WAY User Manual

Top Load 4-Way Instruction Sheet

9

12324

AnoSkybox™

Parts

Spines with

pre-drilled holes

Instructions for Assembly

Note:

We recommended that two people
assemble this AnoSkybox.

Step 1a

Slide spine into vertical rail.

Corner brackets

1a 1b

Single rails Split rails

Page 1 of 2

Step 1b

Slide another vertical rail onto the
other edge of spine. Repeat for all
vertical rails and spines.

Step 2

Carefully insert corner brackets into
ends of
shown in illustration. Two brackets
per end of each rail. Bracket can
bend if forced.

Detail- It is important that the corner
bracket tension tab faces toward
outside of frame. (2b)

bottom rails, using thumb as

Step 3

Lay out the bottom rails on the floor as
they will be configured.

2a 2b

3

2

4-Way

(Continued on other side)

The AnoSkybox™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #03INAnoSkyboxTopLoad4Way

Incept-2.07.03

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

Top Load 3-Way Instruction Sheet

AnoSkybox™

Instructions for Assembly continued

Step 4

Assemble the vertical rail assemblies
onto the upward facing corner brackets
already inserted into the bottom rails.
All four brackets should go into the
vertical rails at one time.

Note: The last vertical rail will be
tensioned. This is normal.

Note: Insert end of spine
predrilled holes. Holes should
remain at the top of the AnoSkybox
for hanging.

without the

Step 5

Insert corner brackets into ends
of split rails, 1 per end. Use thumb
as shown in illustration.

4 5

6

Page 2 of 2

7

Step 6

Assemble split rails onto top ends
of vertical rails, one inside and one
outside of each side of the AnoSkybox.

Step 7

Insert and change signs through top
of each side.

Step 8

Assemble hanging hardware by
inserting hooks through holes on the
spines.

Step 9

Hang the completed assembly.

Note: Steps 7-9 illustrate a 3-Way
AnoSkybox. Assembly is the same for
a 4-Way

8

9

The AnoSkybox™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #03INAnoSkyboxTopLoad4Way

Incept-2.07.03

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]