Rose displays ANOQUICK SQUARE WITH GOTCHA AND MULTICLIPS User Manual

AnoQuickTM with Gotcha® Insert

Parts

Instruction Sheet

AnoQuick

Square Profile

12A300SQ

Instructions for Hanging

Instructions for Hanging

Step 1

Place poster on a flat surface. Snap the Gotcha
Holder open and insert poster (top and bottom).
To close, snap the Gotcha Holder shut. Fig. 1

Note: It is easier to open and close the Gotcha
Holder by starting at one end and working your
way down the holder.

Step 2

Slide the Gotcha Holder into the AnoQuick
Holder. Fig. 2

Step 3

Install the MultiClips in top AnoQuick Holder.
Holding clip at slight angle, first insert one round
end, then press down on the other round end and
push MultiClip into holder. Insert second
MultiClip. Fig. 3 & 4

Gotcha® Special

(no clip rail)

MultiClip

1UP-0100

Figure 1

Square End Cap

06-5545

Figure 2

Step 4

Push end caps into place. Fig. 4
Note: To remove Gotcha (and sign), simply rotate

end cap up out of the way.

Step 5

Suspend poster.

Important note:

Please save and reuse the AnoQuick Holder,
Gotcha Holder, End Caps and MultiClips for future
projects.

The AnoQuick
Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoQuickSQGotchaMC

Incept-9.9.02

TM

is a trademark and Gotcha® is a registered trademark of

Figure 4

Figure 3

Figure 5

35 Congress Street, Salem MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

AnoQuickTM with Gotcha

®

Parts

Insert

Instruction Sheet

AnoQuick

Square Profile

12A300SQ

Instructions for Hanging

Instructions for Hanging

Step 1

Place poster on a flat surface. Snap the Gotcha
Holder open and insert poster (top and bottom).
To close, snap the Gotcha Holder shut. Fig. 1

Note: It is easier to open and close the Gotcha
Holder by starting at one end and working your way
down the holder.

Step 2

Slide the Gotcha Holder into the AnoQuick
Holder. Fig. 2

Step 3

Install the MultiClips in top AnoQuick Holder.
Holding clip at slight angle, first insert one round
end, then press down on the other round end and
push MultiClip into holder. Insert second
MultiClip. Fig. 3 & 4

Step 4

Push end caps into place. Fig. 5
Note: To remove Gotcha (and sign), simply rotate

end cap up out of the way.

Gotcha® Special

(no clip rail)

MultiClips

1UP-0100

Figure 1

Square End Caps

06-5545

Figure 2

Figure 3

Step 5

Suspend poster.

Important note:

Please save and reuse the AnoQuick, Gotcha Holder,
End Caps and MultiClips for future projects.

The AnoQuickTM is a trademark and Gotcha® is a registered trademark of
Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoQuickSQGotchaMC

Incept-9.9.02

Figure 4

Figure 5