Rose displays ANOQUICK ROUND WITH GOTCHA AND MULTICLIPS User Manual

AnoQuick™ with Gotcha® Insert

Parts

Instruction Sheet

AnoQuick

12A300R

Instructions for Hanging

Instructions for Hanging

Step 1

Place poster on a flat surface. Snap the Gotcha
Holder open and insert poster (top and bottom).
To close, snap the Gotcha Holder shut. Fig. 1

Note: It is easier to open and close the Gotcha
Holder by starting at one end and working your way
down the holder.

Step 2

Slide the Gotcha Holder into the AnoQuick Holder.

Fig. 2

Step 3

Install MultiClips in the top AnoQuick Holder.
Holding clip at slight angle, first insert one round
end, then press down on other round end and push
MultiClip into holder. Insert second MultiClip.

Fig. 3 & 4

Gotcha® Special

(no clip rail)

MultiClips

1UP-0100

Figure 1

End Caps

06-5525

Figure 2

Figure 3

Step 4

Push end caps into place. Fig. 5
Note: To remove Gotcha (and sign), simply rotate

end cap up out of the way.

Step 5

Suspend poster.

Important note:

Please save and reuse the AnoQuick Holder, Gotcha
Holder, End Caps and MultiClips for future projects.

The AnoQuickTM is a trademark and Gotcha® is a registered trademark of
Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use of these
products. Part #02INSAnoQuickGotchaMC

Incept-9.9.02

Figure 4

Figure 5

35 Congress Street, Salem MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

AnoQuick™ with Gotcha® Insert

Parts

OneUp

®

Instruction Sheet

AnoQuick

12A300R

Instructions for Hanging

Instructions for Hanging

Step 1

Place poster on a flat surface. Snap the Gotcha
Holder open and insert poster (top and bottom).
To close, snap the Gotcha shut. Fig. 1

Note: It is easier to open and close the Gotcha
Holder by starting at one end and working your way
down the holder.

Step 2

Slide the Gotcha Holder into the AnoQuick
Holder. Fig. 2

Step 3

Install MultiClip in the top AnoQuick Holder.
Holding clip at slight angle, first insert one round
end, then press down on other round end and push
MultiClip into holder. Fig. 3

Gotcha® Special

(no clip rail)

MultiClip

1UP-0100

Figure 1

End Caps

06-5525

Figure 2

Note: For OneUp applications place the MultiClip
in the center of the AnoQuick Holder. Fig. 4

Step 4

Push end caps into place. Fig. 5
Note: To remove Gotcha (and sign), simply rotate

end cap up out of the way.

Step 5

Suspend poster.

Important note:

Please save and reuse the AnoQuick Holder, Gotcha
Holder, End Caps and MultiClips for future projects.

The AnoQuickTM is a trademark and Gotcha® is a registered trademark of
Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use of these
products. Part #02INSAnoQuickGotchaMC

Incept-9.9.02

Figure 4

Figure 3

Figure 5

35 Congress Street, Salem MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]