Rose displays ANOQUICK ROUND WITH CABLE AND CRIMP SLEEVES User Manual

AnoQuick™

Instruction Sheet

Parts

Crimp Sleeves

80-0101

Instructions For Hanging

Step 1

Prepare edges of graphic. Place the graphic on
tabletop with one edge at the table edge. Using
the AnoQuick Holder, run it across the graphic
edge, crushing it slightly. Fig. 1

Step 2

Starting at one corner, push the holder onto the
graphic. Work your way down the holder tapping
it down firmly to seat the graphic fully. Fig. 2

AnoQuick

12A300

MultiClips

1UP-0100

End Caps

06-5525

Figure 1

Cable

and Ball

16-0018B

Figure 2

Step 3

Slide MultiClip into top of AnoQuick Holder.
Holding clip at slight angle, first insert one
round end, then press down on other round
end and push MultiClip into holder. Insert
second MultiClip. Fig. 3
Place each MultiClip about 1/3 from the edge of
the poster. Fig. 4

Step 4

Use Crimp Sleeves to form a loop to secure the
cable to the MultiClip. Fig. 5
Use pliers to crimp the sleeve securely to form the
loop. Trim any excess cable after crimping.

Step 5

Push end caps into place. Fig. 6

Important note:

Please save and reuse the AnoQuick Holder,
End Caps and MultiClips for future projects.

The AnoQuick is a registered trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss
or damage resulting from the use of these products. Part
#02INSAnoQuickLoopBall

Incept-8.15.02

Figure 4

Tel# [phone] Fax# [phone]

Figure 3

Figure 5

Figure 6

35 Congress Street, Salem MA 01970

e-mail:[e-mail]

AnoQuick™

Instruction Sheet

Parts

Crimp Sleeves

80-0101

Instructions For Hanging

Step 1

Prepare edges of graphic. Place the graphic on
tabletop with one edge at the table edge. Using
the AnoQuick Holder, run it across the graphic
edge, crushing it slightly. Fig. 1

Step 2

Starting at one corner, push the holder onto the
graphic. Work your way down the holder tapping
it down firmly to seat the graphic fully. Fig. 2

AnoQuick

12A300

MultiClips

1UP-0100

End Caps

06-5525

Figure 1

Cable

and Ball

16-0018B

Figure 2

Step 3

Slide MultiClip into top of AnoQuick Holder.
Holding clip at slight angle, first insert one
round end, then press down on other round
end and push MultiClip into holder. Insert
second MultiClip. Fig. 3
Place each MultiClip about 1/3 from the edge of
the poster. Fig. 4

Step 4

Use Crimp Sleeves to form a loop to secure the
cable to the MultiClip. Fig. 5
Use pliers to crimp the sleeve securely to form the
loop. Trim any excess cable after crimping.

Step 5

Push end caps into place. Fig. 6

Important note:

Please save and reuse the AnoQuick Holder,
End Caps and MultiClips for future projects.

The AnoQuick is a registered trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss
or damage resulting from the use of these products. Part
#02INSAnoQuickLoopBall

Figure 4

Figure 3

Figure 5

Figure 6

Incept-8.15.02