Telescoping
AnoGotcha
™
Stand
Instruction Sheet
#97-0500
Read this instruction sheet carefully
before assembly. Separate all parts and
check quantities. Make sure all parts
are accounted for before discarding
any packaging materials.
If you experience any problems with
the assembly, please call Rose Displays
at 1-800-631-9707, ext. 5510
Parts
AnoGotcha
Shells
Important terms:
top AnoGotcha holder
vertical post
Here are all the parts required to assemble 1 Telescoping AnoGotcha Stand.
T-Gotchas
11” round bases
vertical poles
with telescoping
locks
ball knobs &
threaded rods
shaped
end caps
telescoping locks
ball knobs
bottom
AnoGotcha holder
11” round base
AnoGotcha is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any
sales agent may be held liable for injury, loss or damage resulting from the use of these products.
Part #02INSTeleAnoGotchaStand
Finished look.
35 Congress Street, Salem, MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Te l e s c o p i n g
AnoGotcha
™
Stand
assembly continued
Step 1
• Locate four ball knobs and
two threaded rods.
• Screw one ball knob
onto one end of each
threaded rod.
Note:
Do not screw a ball
knob onto both ends
of threaded rods.
Step 2
• Screw the end of one
vertical pole onto the
threaded stud of each
11” round base.
• Repeat for both poles.
Screw ball knobs onto threaded rods.
Screw vertical poles into 11” round bases.
Screw ball knob on one end of
threaded rod and tighten.
You should now have one ball knob on one end of each threaded rod.
vertical
pole
11” round
base
Screw one vertical pole onto each
11” round base.
AnoGotcha is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any
sales agent may be held liable for injury, loss or damage resulting from the use of these products.
Part #02INSTeleAnoGotchaStand
Incept-12.09.02
Tighten with hands.
You should have two matching vertical poles with bases.
35 Congress Street, Salem, MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com