Rose displays ANOGOTCHA SQUARE WITH WALL HANGERS User Manual

AnoGotcha™

Parts

End Caps

06-5525

Instructions for Hanging

Step 1

Insert T-Top Gotcha Holder into
AnoGotcha Shell. Fig. 1

Step 2

Push end caps into place. Fig. 2

AnoGotcha Shell

12AG400

T-Top Gotcha

Instruction Sheet

Wood Screws

Frame Wall

Mounting Hanger

06-6067

or Molly Anchors

16-0016

2010SC

Step 3

Snap the AnoGotcha Holder completely
open so that hinge is turned up as far as
possible. Insert poster into holder until top of
poster meets top of holder. To close snap the
AnoGotcha Holder shut. Fig. 3

With large or curling graphics, it may be easier to
insert graphic at one end and slide into holder
from one end to another.

Step 4

Install Wall Mounting Hangers using
wood screws and a Phillips head screwdriver.
Make sure that the Wall Mounting Hangers
are level. Fig. 4

Step 5

Suspend poster.

Important note:

Please save and reuse the AnoGotcha Holder,
End Caps and MultiClips for future projects.

Figure 1

Figure 2

Figure 3

Figure 4

AnoQuick™ and AnoGotcha™ are trademarks and Gotcha® is a registered
trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales
agent may be held liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoGotchaSQWallHangers

Incept-9.9.02

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

AnoGotcha™

Parts

End Caps

06-5525

Instructions for Hanging

Step 1

Insert T-Top Gotcha Holder into
AnoGotcha Shell. Fig. 1

Step 2

Push end caps into place. Fig. 2

AnoGotcha Shell

12AG400

T-Top Gotcha

Instruction Sheet

Wood Screws

Frame Wall

Mounting Hanger

06-6067

or Molly Anchors

2010SC
16-0016

Step 3

Snap the AnoGotcha Holder completely
open so that hinge is turned up as far as
possible. Insert poster into holder until top of
poster meets top of holder. To close snap the
AnoGotcha Holder shut. Fig. 3

With large or curling graphics, it may be easier to
insert graphic at one end and slide into holder
from one end to another.

Step 4

Install Wall Mounting Hangers using
wood screws and a Phillips head screwdriver.
Make sure that the Wall Mounting Hangers
are level. Fig. 4

Step 5

Suspend poster.

Important note:

Please save and reuse the AnoGotcha Holder,
End Caps and MultiClips for future projects.

Figure 1

Figure 2

Figure 3

Figure 4

AnoQuick™ and AnoGotcha™ are trademarks and Gotcha® is a registered
trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales
agent may be held liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoGotchaSQWallHangers

Incept-9.9.02