Rose displays ANOGOTCHA SQUARE WITH CABLE CLIP AND BALL CHAIN User Manual

AnoGotcha™

Parts

OneUp Instruction Sheet

Ball Chain

96-0302P

AnoGotcha Shell

12AG400SQ

Instructions for Hanging

Step 1

Insert T-Top Gotcha Holder into AnoGotcha
Shell. Fig. 1

Step 2

Insert single ball of ball chain into inner
channel of Cable Clip. The cable should snap
into place. Fig. 2

Step 3

Align one round end of cable clip with top
channel of the aluminum rail and insert.
Once in place, insert end of ball chain into
channel. Then press down on the other
round end of the cable clip and slide into rail
by pushing on the clip. Fig. 3

Note: Be sure to slide the ball chain into
place by pushing on the cable clip. Do not
pull on, or push against, the ball chain as
this will cause it to bind in the channel.
Note: For OneUp Application place

the Cable Clip in the center of the
AnoGotcha Holder.

Step 4

Push end caps into place. Fig. 4

Step 5

Snap the AnoGotcha Holder open and insert
poster (top and bottom). To close, snap the
AnoGotcha Holder shut. Fig. 5

Step 6

Suspend poster. Fig. 6

T-Top Gotcha

12GT100

Figure 1

Cable Clip

06-5050

End Caps

06-5545

Figure 2

Figure 3

Figure 4

Figure 5 Figure 6

AnoQuick™ and AnoGotcha™ are trademarks and Gotcha® is a registered
trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales
agent may be held liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoGotchaSQCableClipBallChain

Incept-7.29.02

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

AnoGotcha™

Parts

OneUp Instruction Sheet

Ball Chain

96-0302P

AnoGotcha Shell

12AG400SQ

Instructions for Hanging

Step 1

Insert T-Top Gotcha Holder into AnoGotcha
Shell. Fig. 1

Step 2

Insert single ball of ball chain into inner
channel of Cable Clip. The cable should snap
into place. Fig. 2

Step 3

Align one round end of cable clip with top
channel of the aluminum rail and insert.
Once in place, insert end of ball chain into
channel. Then press down on the other
round end of the cable clip and slide into rail
by pushing on the clip. Fig. 3

Note: Be sure to slide the ball chain into
place by pushing on the cable clip. Do not
pull on, or push against, the ball chain as
this will cause it to bind in the channel.
Note: For OneUp Application place

the Cable Clip in the center of the
AnoGotcha Holder.

Step 4

Push end caps into place. Fig. 4

Step 5

Snap the AnoGotcha Holder open and insert
poster (top and bottom). To close, snap the
AnoGotcha Holder shut. Fig. 5

Step 6

Suspend poster. Fig. 6

T-Top Gotcha

12GT100

Figure 1

Cable Clip

06-5050

End Caps

06-5545

Figure 2

Figure 3

Figure 4

Figure 5 Figure 6

AnoQuick™ and AnoGotcha™ are trademarks and Gotcha® is a registered
trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales
agent may be held liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoGotchaSQCableClipBallChain

Incept-7.29.02