Rose displays ANOGOTCHA ROUND WITH WINDOW MOUNTS User Manual

AnoGotcha™

Parts

Instruction Sheet

AnoGotcha Shell

12AT300

Instructions for Hanging

Step 1

Insert T-Top Gotcha Holder into AnoGotcha
Shell. Fig. 1

Step 2

Snap the AnoGotcha Holder completely open
so the hinge is turned up as far as possible.
Insert poster into holder until top of poster
meets top of holder. To close snap the
AnoGotcha Holder shut. Fig. 2
With large or curling graphics, it may be easier
to insert graphic at one end and slide into
holder from one end to another.

Step 3

Slide Wally Window Mount into top rail of the
Improved AnoGotcha holder. Fig. 3

T-Top Gotcha

12GT100

Figure 1

Window Mounts

20-0038

End Caps

06-5525

Figure 2

Step 4

Push end caps into place. Fig. 4

Step 5

Suspend poster. Make sure glass and suction
cups are clean and free of dust and dirt. Fig. 5

Important note:

For best performance when first applied and
occasionally thereafter, press the middle of the
cup to “burp” extra air out.

The AnoGotcha® is a registered trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoGotchaWindowMounts

Incept-9.10.02

Figure 3

Figure 4

Figure 5

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

AnoGotcha™

Parts

Instruction Sheet

AnoGotcha Shell

12AT300

Instructions for Hanging

Step 1

Insert T-Top Gotcha Holder into AnoGotcha
Shell. Fig. 1

Step 2

Snap the AnoGotcha Holder completely open
so the hinge is turned up as far as possible.
Insert poster into holder until top of poster
meets top of holder. To close snap the
AnoGotcha Holder shut. Fig. 2
With large or curling graphics, it may be easier
to insert graphic at one end and slide into
holder from one end to another.

Step 3

Slide Wally Window Mount into top rail of the
Improved AnoGotcha holder. Fig. 3

T-Top Gotcha

12GT100

Figure 1

Window Mounts

20-0038

End Caps

06-5525

Figure 2

Step 4

Push end caps into place. Fig. 4

Step 5

Suspend poster. Make sure glass and suction
cups are clean and free of dust and dirt. Fig. 5

Important note:

For best performance when first applied and
occassionally thereafter, press the middle of the
cup to “burp” extra air out.

The AnoGotcha® is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoGotchaWindowMounts

Incept-9.10.02

Figure 3

Figure 4

Figure 5