Rose Displays ANOFRAME VERSAMOUNT SCREW BASE SQ User Manual

AnoFrame VersaMount

TM

Screw Base

#97-0451SQ

Parts

AnoFrame

Rails

AnoFrame
Split Rails

Instructions For Assembly

Step 1

Locate the two split rails and the solid
rail that is the same length as the split
rails.
Insert two corner brackets into each
end of the solid side Ano rail. Insert
one corner bracket into each end of
each split side Ano rail. Fig. 2

Note: Tension tabs on corner
brackets face towards outside of
frame. Fig. 1

Corner

Brackets

Instruction Sheet (page 1 of 2)

Screw Tabs

Transitional

Collars

Figure 1

Posts

Screws

solid rail

Screw
Bases

Wood Screws

or Togglebolts

split rails

Figure 2

Step 2

For ceiling application, slide screw
tabs into channel of top Ano rail. For
wall applications, slide into side Ano
rail. Fig. 3.

Step 3

Place one transitional collar over each
screw tab and push onto frame. Fig. 4.

Step 4

Finish assembling frame following the
sequence in Fig. 5.

Note: Placement of split rails will
depend on type of frame. Split rails
will be on the top for top-loading
frames and on the side for side­loading frames.

The AnoFrame VersaMount is a trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss
or damage resulting from the use of these products.
Part #02INSVersaMountScrewBaseSQ

Incept-9.06.02

Figure 3

Figure 4

solid rail

split rails

solid rail

Figure 5

35 Congress Street, Salem MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

AnoFrame VersaMount

TM

Screw Base

#97-0451SQ

Parts

Instructions For Assembly

Step 5

Screw posts onto screw tabs and
tighten. Fig. 6

Note: Use the end of the post with
the smaller opening.

Step 6

Insert one screw into the middle
opening on each screw base and into
the post. Fig 7
Tighten with screwdriver. Fig. 8

Step 7

Install screw bases using wood screws
and screwdriver. Fig. 9

Note: Togglebolts are recommended
for drywall installations (predrilling
3/8” holes is necessary)

Instruction Sheet (page 2 of 2)

Figure 6

Figure 8

Figure 7

Figure 9

Step 8

Slide your graphic into the AnoFrame.

Fig. 10

The AnoFrame VersaMount is a trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss
or damage resulting from the use of these products.
Part #02INSVersaMountScrewBaseSQ

Incept-9.06.02

Figure
10

Finished Look

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]