Rose displays ANOFRAME VERSAMOUNT CLAMP BASE User Manual

AnoFrame VersaMount

TM

Clamp Base

#97-0421

Parts

AnoFrame

Rails

AnoFrame
Split Rails

Instructions For Assembly

Step 1

Locate the two split rails and the solid
rail that is the same length as the split
rails.
Insert corner brackets into side
AnoFrame rails. Insert two corner
brackets into each end of the solid side
Ano rail. Insert one corner bracket
into each end of each split side Ano
rail. Fig. 1 & Fig. 2

Note: Tension tabs on corner
brackets face towards outside of
frame.

Corner

Brackets

Instruction Sheet (page 1 of 2)

Screw Tab Transitional

Collar

Figure 1

Ver tical

Post

solid rail

Figure 2

Clamp Base

split rails

Step 2

Slide screw tab into channel of bottom
Ano rail. Fig. 3.

Step 3

Place transitional collar over screw tab
and push onto frame. Fig. 4.

Step 4

Finish assembling frame following the
sequence in Fig. 5.

Note: Placement of split rails will
depend on type of frame. Split rails
will be on the top for top-loading
frames and on the side for side­loading frames.

The AnoFrame VersaMount is a trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss
or damage resulting from the use of these products.
Part #02INSVersaMountClampBase

Incept-9.6.02

Figure 3

Figure 4

solid rail

split rails

solid rail

Figure 5

35 Congress Street, Salem MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

AnoFrame VersaMount

TM

Clamp Base

#97-0421

Parts

Instructions For assembly

Step 5

Screw vertical post onto screw tab on
frame and tighten. Fig. 6

Note: Use the end of the post with
the smaller opening.

Step 6

Screw the clamp base onto the end of
the vertical post and tighten. Fig 7

Step 7

Slide your graphic into the AnoFrame.

Fig. 8

Instruction Sheet (page 2 of 2)

Figure 6

Figure 8

Figure 7

Finished Look

The AnoFrame VersaMount is a trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss
or damage resulting from the use of these products.
Part #02INSVersaMountClampBase

Incept-9.6.02

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]