Rose displays ANOFRAME SQUARE WITH CABLE CLIP AND BALL CHAIN User Manual

AnoFrame

Parts

TM

Instruction Sheet

Ball Chains

96-0302P

Corner

brackets

Instructions for assembly

Step 1

Insert corner brackets into vertical AnoFrame
sides. Fig. 1 & Fig. 2. Note: Assembly

brackets tension tabs face towards outside of
frames. Split rail side is made up of 2 separate

pieces.

Step 2

Insert single ball of ball chain into inner
channel of Cable Clip. The cable should snap
into place. Fig. 3

Step 3

Align one round end of cable clip with top
channel of the aluminum rail and insert. Once
in place, insert end of ball chain into channel.
Then press down on the other round end of the
cable clip and slide into rail by pushing on the
clip. Fig. 4 Repeat steps 2 & 3 for second cable
clip.

Note: Be sure to push on the cable clip in
order to slide the ball chain into place. Do
not pull on, or push against, the ball chain as
this will cause it to bind in the channel.

Step 4

Assemble frame following steps in. Fig. 5
sliding sides together in the order shown.

AnoFrame rails

12AF100

Figure 1

Figure 3

solid rail w/

3

solid rail

AnoFrame

split rails

split rails

4

Cable Clips

1

solid rail

Figure 2

Figure 4

06-5050

2

split rails

Step 5

Insert poster. Fig 6.

The AnoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameCableClipBallChain

Incept-9.24.02

Figure 5

Figure 6

35 Congress Street, Salem, MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

AnoFrame

Parts

TM

Instruction Sheet

Ball Chains

96-0302P

Corner

brackets

Instructions for assembly

Step 1

Insert corner brackets into vertical
AnoFrame sides. Fig. 1 & Fig. 2. Note:

Assembly brackets tension tabs face to­wards outside of frames. Split rail side is

made up of 2 separate pieces.

Step 2

Insert single ball of ball chain into inner
channel of Cable Clip. The cable should
snap into place. Fig. 3

Step 3

Align one round end of cable clip with top
channel of the aluminum rail and insert.
Once in place, insert end of ball chain into
channel. Then press down on the other
round end of the cable clip and slide into rail
by pushing on the clip. Fig. 4 Repeat steps 2
& 3 for second cable clip.

Note: Be sure to slide the ball chain into
place by pushing on the cable clip. Do not
pull on, or push against, the ball chain as
this will cause it to bind in the channel.

Step 4

Assemble frame following steps in. Fig. 5
sliding sides together in the order shown.

AnoFrame rails

12AF100

Figure 1

Figure 3 Figure 4

solid rail w/

3

solid rail

AnoFrame

split rails

split rails

4

Cable Clips

06-5050

1

solid rail

Figure 2

2

split rails

Step 5

Insert poster. Fig 6.

The AnoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameCableClipBallChain

Incept-9.24.02

Figure 5

Figure 6