Rose displays ANOFRAME ROUND WITH 4 WALL MOUNTS User Manual

AnoFrame™

Round Profile Instruction Sheet

Parts

Corner

Brackets

Instructions For Hanging

Step 1

Locate the two split rails and the solid rail that is the
same length as the split rails.
Insert corner brackets into side AnoFrame rails.
Insert two corner brackets into each end of the solid
side Ano rail. Insert one corner bracket into each
end of each split side Ano rail. Fig. 1 & Fig. 2

Note: Tension tabs on corner brackets face
towards outside of frame.

Step 2

Finish assembling frame by following sequence in

Fig. 3.

Step 3

Install wall mounting hangers using a Phillips head
screwdriver. Make sure that the wall mounting
hangers are level.. A plastic expansion anchor is
suggested for drywall installations.

Fig. 4

Step 4

Slide AnoFrame onto wall mounting hangers. Fig 5.

Step 5

Install bottom mounting hangers. This secures
frame in place. Fig 6

Step 6

Insert poster. Fig 7

AnoFrame Rails

12AF-100

Figure 1

solid rail

solid rail

Figure 3

AnoFrame
Split Rails

split rails

Wall Mounting

Hangers

06-6067

solid rail

split rails

Figure 2

Figure 4

Note: The AnoFrame shown here is a round
profile. It is available in either square or round
profile.

The AnoFrame is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrame4Hangers

Incept-8.15.02

Figure 5

Figure 6 Figure 7

35 Congress Street, Salem MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

AnoFrame™

Round Profile Instruction Sheet

Parts

Corner

Brackets

Instructions For Hanging

Step 1

Locate the two split rails and the solid rail that is the
same length as the split rails.
Insert corner brackets into side AnoFrame rails.
Insert two corner brackets into each end of the solid
side Ano rail. Insert one corner bracket into each
end of each split side Ano rail. Fig. 1 & Fig. 2

Note: Tension tabs on corner brackets face
towards outside of frame.

Step 2

Finish assembling frame by following sequence in

Fig. 3.

Step 3

Install wall mounting hangers using a Phillips head
screwdriver. Make sure that the wall mounting
hangers are level.. A plastic expansion anchor is
suggested for drywall installations.

Fig. 4

Step 4

Slide AnoFrame onto wall mounting hangers. Fig 5.

Step 5

Install bottom mounting hangers. This secures
frame in place. Fig 6

Step 6

Insert poster. Fig 7

AnoFrame Rails

12AF-100

Figure 1

solid rail

solid rail

Figure 3

AnoFrame
Split Rails

split rails

Wall Mounting

Hangers

06-6067

solid rail

split rails

Figure 2

Figure 4

Note: The AnoFrame shown here is a round
profile. It is available in either square or round
profile.

The AnoFrame is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrame4Hangers

Incept-8.15.02

Figure 5

Figure 6 Figure 7