Rose displays ANOFRAME ROUND WITH 2 WALL MOUNTS User Manual

AnoFrame™

Round Profile Instruction Sheet

Parts

Corner

Brackets

Instructions For Hanging

Step 1

Locate the two split rails and the
solid rail that is the same length as
the split rails.
Insert corner brackets into side
AnoFrame rails. Insert two corner
brackets into each end of the solid
side Ano rail. Insert one corner
bracket into each end of each split
side Ano rail. Fig. 1 & Fig. 2

Note: Tension tabs on corner
brackets face towards outside of
frame.

AnoFrame Rails

12AF-100

Figure 1

solid rail

AnoFrame
Split Rails

split rails

Wall Mounting

Hangers

06-6067

solid rail

split rails

Figure 2

Step 2

Finish assembling frame by follow­ing sequence in Fig. 3.

solid rail

Step 3

Install wall mounting hangers using
a Phillips head screwdriver. A
plastic expansion anchor is sug­gested for drywall installations.

Fig. 4

Step 4

Slide AnoFrame onto wall mount­ing hangers. Fig 5. Insert poster.

Note: The AnoFrame shown here
is a round profile. It is available
in either square or round profile.

The AnoFrame is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameWallHangers

Incept-8.15.02

Figure 3

Figure 4

Figure 5

35 Congress Street, Salem MA 01970

Tel# [phone] Fax# [phone]

e-mail:[e-mail]

AnoFrame™

Round Profile Instruction Sheet

Parts

Corner

Brackets

Instructions For Hanging

AnoFrame Rails

12AF-100

AnoFrame
Split Rails

Wall Mounting

Hangers

06-6067

Step 1

Locate the two split rails and the
solid rail that is the same length as
the split rails.
Insert corner brackets into side
AnoFrame rails. Insert two corner
brackets into each end of the solid
side Ano rail. Insert one corner
bracket into each end of each split
side Ano rail. Fig. 1 & Fig. 2

Note: Tension tabs on corner
brackets face towards outside of
frame.

Step 2

Finish assembling frame by following
sequence in Fig. 3.

Step 3

Install wall mounting hangers using
a Phillips head screwdriver. A plastic
expansion anchor is suggested for
drywall installations.

Fig. 4

solid rail

solid rail

Figure 3

Figure 1

solid rail

split rails

Figure 2

split rails

Figure 4

Step 4

Slide AnoFrame onto wall mounting
hangers. Fig 5. Insert poster.

Note: The AnoFrame shown here
is a round profile. It is available in
either square or round profile.

The AnoFrame is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameWallHangers

Incept-8.15.02

Figure 5