Rose Remote Control Keypad User Manual

Remote Control Keypad

10707 Stancliff Road Phone: [phone]
Houston, Texas 77099 WWW.ROSE.COM

LIMITED WARRANTY

Rose Electronics warrants the Remote Control Keypad™ to be in good working order for one year from
the date of purchase from Rose Electronics or an authorized dealer. Should this product fail to be in
good working order at any time during this one-year warranty period, Rose Electronics will, at its option,
repair or replace the Unit as set forth below. Repair parts and replacement units will be either
reconditioned or new. All replaced parts become the property of Rose Electronics. This limited warranty
does not include service to repair damage to the Unit resulting from accident, disaster, abuse, or
unauthorized modification of the Unit, including static discharge and power surges.

Limited Warranty service may be obtained by delivering this unit during the one-year warranty period to
Rose Electronics or an authorized repair center providing a proof of purchase date. If this Unit is
delivered by mail, you agree to insure the Unit or assume the risk of loss or damage in transit, to prepay
shipping charges to the warranty service location, and to use the original shipping container or its
equivalent. You must call for a return authorization number first. Under no circumstances will a unit be
accepted without a return authorization number. Contact an authorized repair center or Rose
Electronics for further information.

ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT INCLUDING THE WARRA NTIE S
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN
DURATION TO A PERIOD OF ONE YEAR FROM THE DATE OF PURCHASE, AND NO
WARRANTIES, WHETHER EXPRESS OR IMPLIED, WILL APPLY AFTER THIS PERIOD. SOME
STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE
ABOVE LIMITATION MAY NOT APPLY TO YOU.

IF THIS PRODUCT IS NOT IN GOOD WORKING ORDER AS WARRANTED ABOVE, YOUR SOLE
REMEDY SHALL BE REPLACEMENT OR REPAIR AS PROVIDED ABOVE. IN NO EVENT WILL
ROSE ELECTRONICS BE LIABLE TO YOU FOR ANY DAMAGES INCLUDING ANY LOST PROFITS,
LOST SAVINGS OR OTHER INCIDENTAL OR CONSEQUENTIAL DA M AGES ARISING OUT OF THE
USE OF OR THE INABILITY TO USE SUCH PRODUCT, EVEN IF ROSE ELECTRONICS OR AN
AUTHORIZED DEALER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES, OR FOR
ANY CLAIM BY ANY OTHER PARTY.

SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES FOR CONSUMER PRODUCTS, SO THE ABOVE MAY NOT APPLY
TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE
OTHER RIGHTS WHICH MAY VARY FROM STATE TO STATE.

NOTE: This equipment has been tested and found to comply with t he limits f or a Class B digital device,
pursuant to Part 15 of the FCC Rules. These l imits are designed t o provide reasonabl e protection
against harmful in t erference when the equipment is operat ed in a commercial env ironment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful int er feren ce to radio com mun ic ations.
Operation of this equipment in a residen tial area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.

IBM, AT, and PS/2 are t rademarks of International Business Machines Corp. Microsoft and M icrosoft
Windows are registered trademarks of Microsoft Corp. Any other trademarks mentioned in this manual
are acknowledged to be the property of the trademark owner.

Copyright  Rose Electronics 2008. All rights reserved.
No part of this manual may be reproduced, stored in a retrieval system, or transcribed in any form or any
means, electronic or mechanical, including photocopying and recording, without the prior written permission of
Rose Electronics.

Rose Electronics Part # MAN-RCK
Printed In the United States of America –

FCC/IC STATEMENTS, EU DECLAR ATION OF CONF ORMITY

RCK-KP4x5-P

RCK-KP1x16-P

RCK-KP4x5-U

RCK-KP1x16-U

FEDERAL COMMUNICATIONS COMMISSION

AND INDUSTRY CANADA

RADIO-FREQUENCY INTERFERENCE STATEMENTS

Models Included:

This equipment generates, uses and can radiate radio frequency energy and
if not installed and used properly, that is in strict accordance with the
manufacturer’s instructions may cause interference to radio communication.
It has been tested and found to comply with the limits for a Class B digital
device in accordance with the specifications of Part 15 of FCC rules, which
are designed to provide reasonable protection against such interference when
the equipment is operated in a commercial environment. Operation of this
equipment in a residential area is likely to cause interference, in which case
the user at his own expense will be required to take whatever measures may
be necessary to correct the interference.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This digital apparatus does not exceed the Class B limits for radio noise
emission from digital apparatus set out in the Radio Interference Regulation of
Industry Canada.

Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de la classe B
prescrites dans le Règlement sur le brouillage radioélectrique publié par
Industrie Canada.

TABLE OF CONTENTS

Contents Page #

Disclaimer ......................................................................................................... 6

System introduction .......................................................................................... 6

Features ........................................................................................................... 6

Comparison ...................................................................................................... 7

INTRODUCTION

















Disclaimer

While every precaution has been taken in the preparation of this manual, the
manufacturer assumes no responsibility for errors or omissions. Neither does
the manufacturer assume any liability for damages resulting from the use of
the information contained herein. The manufacturer reserves the right to
change the specifications, functions, or circuitry of the product without notice.

The manufacturer cannot accept liability for damages due to misuse of the
product or other circumstances outside the manufacturer’s control. The
manufacturer will not be responsible for any loss, damage, or injury arising
directly or indirectly from the use of this product.

System introduction

Thank you for choosing the Rose Electronics Remote Control Keypad. The
Remote Control Keypad is a unique product that allows you to simplify the
repetitive keystrokes, words, phrases, or commands that you use every day
into a single key. Assign your name to a key and every time you need to type
it into a document, simply press that key.

The Remote Control Keypad is available in a 4 x 5 key or 1 x 16 key model.
All models are available with PS/2 or USB connectors. The PS/2 models
work in conjunction with your PS/2 keyboard. No installation or configuration
is needed. The USB model connects to any unused USB port. It requires the
installation of MMII software which provides additional features not available
with the PS/2 models.

Features

Available in a 4 x 5 button model or 1 x 16 rail, USB or PS/2 models
Dual level programmable, program one key to toggle between levels and

all other keys can be programmed to perform two different functions

Connects in-line with a standard PS/2 keyboard or USB port
Replace any keyboard sequence like a word, phrase, or command with a

single key

Works on any piece of equipment that uses standard PS/2 or USB

keyboard inputs commands like computers, KVM switches, extenders,
etc.

Compatible with all operating systems
Easy to install and program
Keys have a removable keycap for custom key labeling
Can be used as a stand-alone bootable keyboard
Programming each key is a simple as pushing a key, type a phrase, push

the key again and that key is programmed

USB installation software included

USB Models

PS/2 Models

Windows 2000 / XP / Vista

All operating systems
keyboard

Requires MWII or iKEY
software (included)

No software required –
Plug and Play

Accepts all keyboard

scripting

Accepts all keyboard

accessibility options)

Comparison

Operating

Systems

Macintosh OS-X

Installation

commands and sequences,

Commands

mouse, multimedia, launches
applications, opens files and
folders, and supports custom

that accept a PS/2

commands and
sequences
(Mouse click supported
via Windows

10707 Stancliff Road Phone: [phone]
Houston, Texas 77099 WWW.ROSE.COM