Rose CrystalLink Audio User Manual

CrystalLink

CAT5 Audio Extender

Quick Start Guide

On the bottom of the remote unit

Features

Audio / Mic – 3.5mm
Power –

Frequency Response

10 Hz – 25KHz / -3dB (1Vp-p)

Indicators

Power indicator on the remote unit

Audio In impedance

10k Ohms

Audio Input level

1.8Vp-p

Mic Input level

0.5Vp-p

MAX. Mic gain

0 to +15dB

Cable Distance

1,000 feet (300 m) Max.

Power Adapter

120V 60Hz / 9VDC 300mA

Weight

Local unit – 2.29 oz / 65 g
Remote unit – 2.32 oz / 66 g

Dimensions

Length Width Height

3.6 In/92mm 1.34 In/34mm 0.87 In/22mm

LOCAL UNIT

REMOTE UNIT

MIC LINE

MIC LINE

OUT IN

 Extend the distance of stereo audio and a microphone up to 1,000 feet

(300 meter) from your PC or audio source over CAT5 cable.

 Remote unit obtains its power via CAT5 cable from the local unit.
 Audio Out supports multimedia speakers, headphones or earphones.
 Mic In supports both condenser and dynamic microphone.
 Built-in microphone preamplifier.
 Microphone gain adjustment

Specifications

Perform the following steps to install
the CrystalLink CAT5 Audio Extender

1- Connect the Local unit’s Mic Out and Line In ports to the

corresponding ports on your PC or audio source using a 3.5mm
male to male audio cable.

2- Connect a Microphone to the Remote unit’s Mic Input port

and a set of speakers to the Remote unit’s Line Out port.

3- Connect the local unit to the remote unit with up to 1,000 feet

(300 meters) of CAT5 cable.

4- Connect the power adapter to the local unit’s +9VDC power jack

and a power source

IN OUT

there is a microphone gain control
adjustment. Turning the adjustment
potentiometer will increase the
microphone gain from 0 to +15dB..

Connectors

Link – RJ45F